Intel Data Center Max 1550 Firmware DUP for baseboard retimer

**The server MUST have iDRAC version 7.00.60.00 or later installed before attempting to update the Retimer firmware**

It is recommended to perform a complete power cycle of the server before installing this firmware.
Disconnect all power sources, wait 30 seconds, and reconnect power to the server.

This firmware will only apply to the Intel Data Center Max 1550 GPU.

====================================================
Installation via iDRAC GUI
====================================================
1. Update the system iDRAC to version 7.00.60.00 or higher.
2. Copy the downloaded Firmware DUP to a local computer.
3. Navigate to the iDRAC GUI
4. Select Maintenance --> System Update.
5. Select location type local, choose saved file from local computer.
6. Click upload.
7. After upload, select the new file option from the GUI screen.
8. Click Install.
9. Installation can be monitored in the iDRAC Job Queue.
*Note their are four Retimers on the baseboard, and each will require 15 minutes to update. Allow 1 hour of time for this job to complete.