PowerConnect,8024,8024F,V3.1.4.5,A02

Fixes and Enhancements:

Enhancements
- Fiber ports support 1Gigabit and 10Gigabit Transceivers
- ISDP Advertise/Display hostname
- Layer 2 Multicast Group
- New PowerConnect 8024 Switch
- ReFormatFLASHFileSystem
- RTAG7 Hashing Mode Support
- VLAN Limit Increases

Fixes
- Able to successfully configure Banner MOTD from WEB, but unable to disable successfully.
- BPDU protection fails when port is in dot1x un-authorized state.
- Bridge multicast forbidden forward- unregistered causes L3 Multicast to fail.
- Code Download is getting failed with HTTPs as management session and downloading protocol as HTTP.
- Configured non-existing host cannot be deleted for logging syslog
- Configured radius accounting attributes do not reflect in running- config.
- Device crashes when enabling Dynamic Arp Inspection and DHCPSnooping on out of range VLAN Id.
- Failed to delete configured radius server key
- FDB entries are not getting deleted on MAB enabled port when the dotx state is changed to force unauthorization
- guest-vlan-timeout' command is missing from CLI.
- Huge running-config display hogs up screen space with downloaded image for captive poral
- IGMP Querier does not work if IP Multicast not enabled.
- IGMP Queriers are sent out from the switch after the pre-configured 60 secs interval
- Interface Configuration web page would not allow the user to set the MTU size to zero.
- IP Source Guard commands are not available in port-channel mode
- Local user database does not accept a user without a password from web, although password minimum length is disabled.
- Location information is not found in CLI / Web when Recurring Summer Time is configured.
- Missing RFC1213 MIB-2 SNMP Trap counter
- MLD Packets are not snooped, when sending MLD packets with Hop-by- Hop header with Router Alert Option.
- No button is selected by default in the copy file web page
- Observed Internal BRCM_escape_lt; brBRCM_escape_gt; words are displayed on clicking Route Redistribution Summary web page
- Out Of Band Port status is shown as UP, even though it's shutdown.
- PFC counters on LAG interface are not incrementing.
- PFC frames received per priority queue are always shown as zero.
- Ports fail to participate in GVRP VLAN on receiving GVRP packet, even though VLAN gets created.
- productIdentificationPerUnitTable OID was re-numbered when banner OIDs were inserted.
- Radius Servers always show active status.
- Radius Servers always show active status.
- Read-write user gets Read-only access for telnet and SSH session, when authentication method is RADIUS.
- Recurring Summer Time is getting configured for max offset value even though offset is not configured.
- Sending multiple DHCP discoveries to the switch results in log messages on the console.
- Sending multiple DHCP discoveries to the switch results in log messages on the console.
- Service Port MAC address is not valid
- Show interfaces advertise ethernet command is not parsed properly.
- show interfaces switchport ethernet' displays Egress Rule as ''------'' for dynamic VLAN's.
- Static IP cannot be configured from WEB
- Summer Time does not work when date falls under configured window.
- Summer Time enabled does not reflect correctly in the output of 'show running-config' and 'show clock detail'.
- Summer Time offset range is not correct.
- Switch crashed when trying to authenticate the Client using MAB
- Switch crashes when File System page is accessed after configuring file descriptor through CLI with more than 128 characters length.
- Switch hangs when invalid image is downloaded into script
- Switch is accepting any letter other than ''y'' to generate SSH key.
- Switch is accepting IGMPv2 Joins with TTL as 64.
- Switch throws errors of level info/debug when clearing or checking PFC interface counters.
- Switch uploads startup-config when tried uploading running-config.