iDRAC with Lifecycle Controller v 2.15.10.10

Fixes:
- VNC password is not retained in iDRAC after an iDRAC reboot.

- Assertion of PSx-PG-Fail in the SEL is automatically de-asserted upon recovery of PSU-Good or removal of related PSU.

- The BIOS configuration job completes with errors when the Virtualization Technology setting is changed. The job status displays an error though the settings are successfully applied.

- The WS-MAN interface stops functioning when running several WS-MAN sessions simultaneously.

- Auto Config may not apply the XML configuration changes if the host system is turned on or while using the Enable Once After Reset DHCP provisioning option.

- iDRAC network access issues after iDRAC configuration is reset to the factory defaults.

- iDRAC network access issues using shared LOM on PowerEdge FC430 servers.

- Reset to default on Dell PowerEdge M820 results in an unexpected behavior. The IP on the system displays as IP on the system is 192.168.0.120 instead of 0.0.0.0.

- On a system with an ID module installed, the ID module network settings are not configured properly during the initial ID module installation and after performing a reset to default.

- Fans run at full speed on systems with mixed PERC cards - one PERC card with battery and another card without battery.

Enhancements:
-Support for the following PowerEdge systems:
- PowerEdge FC430
- PowerEdge FD332

-Support for using single iDRAC firmware across Dell 12th and 13th generation PowerEdge servers.

- Support to switch the controller mode from RAID to HBA and back on PERC 9.1 and later controllers.

- Enables SSL encryption between client and server using 256 bit or higher.

- Added racadm proxy support for PowerEdge FX2 chassis. Allows an iDRAC administrator
utilizing Chassis Management at Server (CMAS) to issue a racadm command to
CMC using iDRAC.

- Added event proxy support for PowerEdge FX2 chassis. Allows an iDRAC managing a PowerEdge FX2 CMC
utilizing CMAS to display CMC events.

- Added support for iDRAC Shared LOM on PowerEdge FX2 chassis.

- Upgraded OpenSSL v1.0.1j;

- Upgraded OpenSSH v6.6;

- Added support for QLogic BCM57xx and BCM57xxx NIC cards.

- Added support for Intel Ethernet Network Adapters X710.

- Added support for the following Emulex network cards:
- Emulex OneConnect OCe14102-U1-D 2-port PCIe 10GbE CNA
- Emulex OneConnect OCm14104-U1-D 4-port 10GbE rNDC CNA
- Emulex OneConnect OCm14102-U5-D 2-port 10GbE Mezz CNA
- Emulex OneConnect OCm14102-U4-D 2-port 10GbE bNDC CNA
- Emulex OneConnect OCe14102-N1-D 2-port PCIe 10GbE NIC
- Emulex OneConnect OCm14104-N1-D 4-port 10GbE rNDC NIC
- Emulex OneConnect OCm14102-N5-D 2-port 10GbE Mezz NIC
- Emulex OneConnect OCm14102-N6-D 2-port 10GbE bNDC NIC