Download Files
File Format: This file format consists of a BIOS executable file. The Universal (Windows/MS DOS) format can be used to install from any Windows or MS DOS environment.
File Name: 5530A12.exe
File size: 8.39 MB
To ensure the integrity of your download, please verify the checksum value.
MD5: 40b1acdf12048b2059ecfc1c7abafcb8
SHA1: ab093b6ff01efafdf1e75412212210cbeab02437
SHA-256: 4160667c473720b62db673db00ddea6499df8b63019b80744cbdfef534af5b66
Fixes & Enhancements
Fixes
-Fixed issue where CCTK requires additional reboot to enable TPM function.
-Fixed issue where system may stop at Intel IRST entering option with Array disk and one Non-RAID ON disk installed.
-Fixed issue where keyboard illumination option may not available.
Enhancements
-Supported BIOS flash update under Windows 8.1.
-Updated to the 8.1.40.1416 version of the Intel management Engine firmware.
Supported Operating Systems
Installation instructions
BIOS Update Executable for Windows/DOS
Download
1. Click Download File to download the file.
2. When the File Download window appears, click Save to save the file to your hard drive.
Run the BIOS update utility from Windows environment
1. Browse to the location where you downloaded the file and double-click the new file.
2. Windows System will auto restart and update BIOS while system startup screen.
3. After BIOS update finished, system will auto reboot to take effect.
Run the BIOS update utility from DOS environment (Non-Windows users)
1. Copy the downloaded file to a bootable DOS USB key.
2. Power on the system, then Press F12 key and Select "USB Storage Device" and Boot to DOS prompt.
3. Run the file by typing copied file name where the executable is located.
4. DOS System will auto restart and update BIOS while system startup screen.
5. After BIOS update finished, system will auto reboot to take effect.
Run the BIOS update utility from DOS environment if UEFI Boot Mode (Non-Windows users)
1. Copy the downloaded file to a bootable DOS USB key.
2. Power on the system, then go to BIOS Setup by pressing F2 and go to "General > Boot Sequence > Boot List Option"
3. Change UEFI to Legacy of Boot List Option
4. Click "Apply", "Exit" to save changes and reboot system.
5. Press F12, then Select "USB Storage Device" and Boot to DOS prompt.
6. Run the file by typing copied file name where the executable is located.
7. After BIOS update finished, system will auto reboot .
8. Go to BIOS Setup by pressing F2 and go to General > Boot Sequence > Boot List Option"
9. Change "Legacy to UEFI Boot Option.
10. Click "Apply", "Exit" to save changes and reboot system.
--------------------------------------------------------------------------------
Note 1: You will need to provide a bootable DOS USB key. This executable file does not create the DOS system files.
Note 2: Please make sure you suspend BitLocker encryption before updating BIOS on a BitLocker enabled system.
If you don't enable BitLocker on your system you can ignore it.