DELL PERC H310 Mini Blades Firmware release 20.13.2-0006

See Install Instructions on how to upgrade to this package.

Performing the Firmware Update

NOTE: This initial section of the Installation Instructions applies only to configurations with (greater than) 2TB

SEDs.

1. Update the firmware version to this version using preferred method below (Windows DUP, Linux DUP, or PERCCLI).
2. Reboot for the new FW take effect
3. Un-assign any (greater than) 2TB SED Dedicated or Global Hot Spares in the configuration. Not all

configurations have hot spares.
4. Use CTRL-R or OMSS to issue Instant Secure Erase to all un-configured (greater than) 2TB SED drives (all data

in these drives will be lost)
5. Re-assign (greater than) 2TB SED Hot Spares.


Windows Update Package:

Download
1. Click the "Download Now" link to download the file.
2. When the File Download window appears, click Save to save the file to
your hard drive.

Installation
1. Browse to the location where you downloaded the file and double-click the new file.
2. Read over the release information presented in the dialog window.
3. Download and install any prerequisites identified in the dialog window
before proceeding.
4. Click the Install button.
5. Follow the remaining prompts to perform the update.


Linux Update Package:

Download
1. Click the Download Now link to download the file.
2. When the File Download window appears, click Save to save the file to your hard drive.

Installation
1. Read over the release information presented by executing the
./FRMW_LX_RXXXXXX.BIN --version command from the shell.
2. Download and install any prerequisites identified in the above step before
proceeding.
3. Run the update by executing ./FRMW_LX_RXXXXXX.BIN from the shell.
4. Follow the remaining prompts to perform the update.

GnuPG Signature of Dell Update Package Instructions for FRMW_LX_RXXXXXX.BIN:

Download
1. Click the Download Now link to download the file.
2. When the File Download window appears, click Save to save the file to your hard drive.

Installation
1. Import the Dell public key. (You only need to do this once on your system.)
2. Verify the Dell Update Package by using its signature file, FRMW_LX_RXXXXXX.BIN.


PERCCLI Install:

Download
1. Click the Download Now link to download the file.
2. When the File Download window appears, click Save to save the file to your hard drive.

Installation
1. Browse to the location where you downloaded the file and double-click the new file.
2. Click the Extract button and extract the Dell Update Package to a folder of your choice.
3. Download the PERCCLI utility for your respective operating system from support.dell.com

(www.dell.com/support/home/us/en/19/Drivers/DriversDetails?driverId=3XDPP).
4. Install PERCCLI.
5. Open a command line prompt.
6. Run 'perccli show' and make note of the controller number for the controller you wish to update. If you only

have one PERC in the system it will be controller 0.
7. Run 'perccli /cx download file=' where x=the index number for the controller you got in step 6.
8. Reboot the server as directed once the firmware flash completes.

Reboot will be required