Download Files
File Format: This file format consists of a BIOS executable file. The Universal (Windows/MS DOS) format can be used to install from any Windows or MS DOS environment.
File Name: 3150A05.exe
File size: 3.87 MB
To ensure the integrity of your download, please verify the checksum value.
MD5: 20d50871b6cac804327e2cbdedacfa92
SHA1: 6a120676b8bb92460e643e2018a83adcfb67bebf
SHA-256: d2f61523d3e6e3e82b8e890bc11a27ad556ca2b1b663d92de146d109d1d78dd6
Fixes & Enhancements
Fixes
- Fixed incorrect function key behavior on Fn + Page Up/Page Down.
- Fixed no network connectivity when boot from SED HDD with UEFI Network Stack Enabled.
Enhancements
- Updated Intel Processor Micro Code.
- Updated the system Embedded Controller Firmware.
Important Information
It is not allowed to downgrade to BIOS A01(or below) due to security concern and stability concern.
Supported Operating Systems
Installation instructions
BIOS Update Executable for Windows/DOS
Download
1. Click "Download File", to download the file.
2. When the File Download window appears, click Save to save the file to your hard drive.
Run the BIOS update utility from Windows environment
1. Browse to the location where you downloaded the file and double-click the new file.
2. Windows System will auto restart and update BIOS while system startup screen.
3. After BIOS update finished, system will auto reboot to take effect.
Run the BIOS update utility from DOS environment, if Legacy Boot mode (Non-Windows users)
1. Copy the downloaded file to a bootable DOS USB key.
2. Power on the system, then Press F12 key and Select "USB Storage Device" and Boot to DOS prompt.
3. Run the file by typing copied file name where the executable is located.
4. DOS System will auto restart and update BIOS while system startup screen.
5. After BIOS update finished, system will auto reboot to take effect.
Run the BIOS update utility from DOS environment if UEFI Boot Mode (Non-Windows users)
1. Copy the downloaded file to a bootable DOS USB key.
2. Power on the system, then go to BIOS Setup by pressing F2 and go to "General > Boot Sequence > Boot List Option".
3. Change "UEFI" to "Legacy" of Boot List Option.
4. Click "Apply", "Exit" to save changes and reboot system.
5. Press F12, then Select "USB Storage Device" and Boot to DOS prompt.
6. Run the file by typing copied file name where the executable is located.
7. After BIOS update finished, system will auto reboot .
8. Go to BIOS Setup by pressing F2 and go to "General > Boot Sequence > Boot List Option".
9. Change "Legacy" to "UEFI" Boot Option.
10. Click "Apply", "Exit" to save changes and reboot system.
--------------------------------------------------------------------------------
Note 1: You will need to provide a bootable DOS USB key. This executable file does not create the DOS system files.
Note 2: Please make sure you suspend BitLocker encryption before updating BIOS on a BitLocker enabled system.
If you don't enable BitLocker on your system you can ignore it.
Reboot will be required