Download Files
File Format: This file format consists of a BIOS executable file. The Universal (Windows/MS DOS) format can be used to install from any Windows or MS DOS environment.
File Name: XPS8910_1.1.8.exe
File size: 7.03 MB
To ensure the integrity of your download, please verify the checksum value.
MD5: 5bc2f26c7dcca962a1652204a5dedb57
SHA1: 91be81b006dd7052669baf4bad2a41acd73c2493
SHA-256: c67694b263967498a4904c0207914434c0f813201669f6fac29f3c3ae97c8714
Fixes & Enhancements
Fixes:
- Firmware updates to address security advisory INTEL-SA-00185 (CVE-2018-12188 CVE-2018-12190 CVE-2018-12191 CVE-2018-12192 CVE-2018-12199 CVE-2018-12198 CVE-2018-12200 CVE-2018-12187 CVE-2018-12196 CVE-2018-12185).
Enhancements:
- Not Applicable.
Supported Operating Systems
Installation instructions
Note 1: Before updating the BIOS, ensure that you suspend BitLocker encryption on a BitLocker-enabled system. If BitLocker is not enabled on your system, you can ignore this step.
Note 2: Do not turn off the power or interrupt the BIOS update process during the update.
Run the BIOS update utility from Windows environment.
Download and Installation
1. Click Download File.
2. Click Save to save the file to your hard drive
3. Browse to the location where you downloaded the file and double-click the new file.
The system restarts automatically and updates the BIOS at the system startup screen. After the BIOS update is complete, system restarts again.
Run the BIOS update utility from DOS environment (Non-Windows users)
Installation
Note: You must provide a bootable USB drive. This executable file does not create the DOS system files.
1. Copy the downloaded file to a bootable USB drive.
2. Power on the system and then Press the F12 key.
3. Select USB Storage Device and boot to the DOS prompt.
4. Run the file by typing following command. For example:
C:\ Precision_5530_X.Y.Z.exe
Where C is the drive letter of the USB device where the executable file is located and Precision_5530_X.Y.Z.exe is the name of the downloaded file.
The system restarts automatically and updates the BIOS at the system startup screen. After the BIOS update is complete, system restarts again.
Updating the BIOS from a DOS environment with UEFI boot mode (Non-Windows users, Load Legacy Option Disabled)
1. Copy the downloaded file to a bootable DOS USB drive.
2. Power on the system and then go to BIOS Setup by pressing the F2 key.
3. Go to General > Boot Sequence > Boot > Boot List Option.
4. Change UEFI to Legacy of Boot List Option.
5. Go to Exit > Save Changes and reboot system.
6. Press F12 and then select USB Storage Device and boot to the DOS prompt.
7. Run the file by typing the file name.
The system restarts automatically and updates the BIOS at the system startup screen. After the BIOS update is complete, the system restarts again.
8. Go to BIOS Setup by pressing the F2 key and go to General > Boot Sequence > Boot > Boot List Option.
9. Change Legacy to UEFI Boot Option.
10. Go to Exit > Save Changes and reboot the system.