Dell Networking N2000 Series, Firmware Version 6.5.1.5

If N2000 series switch has an earlier version of firmware (6.0.0.7 or 6.0.0.8 or 6.0.1.3), upgrade switch to the latest version of firmware 6.5.1.5 as it contains multiple bug fixes.

New CPLD version 20 is available in release 6.5.1.1 and later (6.5.1.5) for both N3000 and N2000 Series switches. After upgrading the switches to FW version 6.5.1.1 and later (6.5.1.5), the CPLD can be updated to version 20 from CLI using the command - "update cpld". To update CPLD on stack members, run - 'devshell cpldUpdate' command from serial console. Please DO NOT power-cycle the switch when CPLD update is in progress. After CPLD update is complete, the switch will reset on it's own. Verify CPLD Version with the command - 'show version' from CLI after switch boot-up completes.

****Below information is applicable ONLY for N2000/N3000 switches upgraded to 6.5.1.5 and CPLD Version 15 or 17 or 20 and attempt to downgrade to any prior FW version****

Downgrading N3000 and N2000 Series switches from firmware version 6.5.1.5 with the updated CPLD version 15 or 17 or 20 (Verify CPLD Version with the command “show version” from CLI) to any prior 6.x.x.x version can ONLY be done by downgrading via interim FW version B.6.3.2(N3000_N2000vB.6.3.2.stk) attached to zip file.

With interim FW image version B.6.3.2 running, the switches should be downgraded to CPLD version 13 first before downgrading to any 6.x.x.x version. Please follow the instructions documented in the “Firmware Downgrade” section of "Upgrading Dell EMC Networking N2000 Series Switches From Version 6.x.x.x to 6.5.1.5" procedure.

Please refer to the Release Notes for fixes and enhancements available in this release. "Release Notes" are included in the zip file - "Dell_EMC_Networking_6.5.1.5_Release_Notes(N1500_N2000_N3000_N3048EP-ON_N4000_PC8100)".