LSI Logic Ultra 320 SCSI Adapter Non-RAID, v. 1.08.04, A01

Contents
========
LSI Logic PCI SCSI/FC MPI Driver

This program creates a Windows NT 4.0 driver diskette for
the LSI Logic SCSI controllers. You will need a formatted 3
1/2 inch floppy diskette for the following procedure.

1) Download the file to a directory on your hard drive. The
file downloaded is a self extracting executable.

2) Double click on the file to run the executable.

3) Click on the unzip button to extract files to the floppy.

Performing a New Installation of Windows NT 4.0
-----------------------------------------------

"Making LSI Logic SCSI the Primary Controller in Windows NT 4.0"

1) Boot the system using the Windows NT 4.0 CD. As the message

"Setup is inspecting your computers hardware configuration"

appears. Press F6 immediately.

2) Within a few seconds, the Windows NT Setup screen
appears, requesting additional adapters in the system.
Press 'S' to specify an additional device, then press
Enter on the OTHER option in the selection screen.

3) Insert the LSI Logic SCSI driver diskette created above
and press Enter.

"Dell PERC 4/im | LSI Logic 1020/1030 Driver (Windows NT)"

appears. Press Enter to load the driver.

4) Press 'S' to load additional mass storage device driver
if required. Otherwise, press Enter to continue
installation process as usual. Windows NT 4.0 continues
to be installed as usual. Please refer to the operating
system installation documentation for further steps.

"Making LSI Logic SCSI a Secondary Controller in Windows NT 4.0"

1) Start the Windows NT 4.0 installation process. Load the
device for the primary controller if necessary.

2) Windows NT Server Setup screen is displayed after loading
Windows NT Kernel. Press Enter to continue.

3) Setup displays mass storage devices that it has
recognized in your computer. Press 'S' to specify an
additional device, then press Enter on the OTHER option
in the selection screen.

4) Insert the LSI Logic SCSI driver diskette created above
and press Enter.

"Dell PERC 4/im | LSI Logic 1020/1030 Driver (Windows NT)"

appears. Press Enter to load the driver.

5) Press 'S' to load additional mass storage device drivers
if required; otherwise, press Enter to continue the
installation process as usual. Windows NT 4.0 continues
to be installed as usual. Please refer to the operating
system installation documentation for further steps.

Adding the LSI Logic SCSI Driver to an Existing Windows NT 4.0 Server
---------------------------------------------------------------------

If your server is already running Windows NT 4.0, then use
the following steps to add the LSI Logic Windows NT 4.0 SCSI
driver.

1) Insert the diskette created above in the floppy drive.

2) Click on Start > Control Panel > Settings. Double-click
on the Small Computer System Interface (SCSI) Adapter
icon.

3) Select the Drivers tab.

4) Click on the Add button.

5) Select Have Disk.

6) The Install From Disk box appears. Specify the location
of the LSI Logic Windows NT 4.0 SCSI driver as the floppy
drive and click on OK.

7) Select "PERC 4/im | LSI Logic 1020/1030 Miniport Driver"
from the floppy drive and click OK to add the LSI Logic
Windows NT 4.0 SCSI driver.

This procedure will install the LSI Logic SCSI drivers for
Windows NT4.0. You must reboot the system after LSI Logic
Windows NT 4.0 SCSI driver installation has completed
successfully.