Schakel uw computer niet uit en koppel de stroomtoevoer niet los tijdens het bijwerken van het BIOS. Dit kan uw computer beschadigen. Tijdens de update wordt uw computer opnieuw opgestart en ziet u mogelijk voor korte tijd een zwart scherm.
Lees voordat u bijwerkt de installatie-instructies en de belangrijke informatie die hieronder is vermeld.
Dell Inspiron 2350 System BIOS
Opnieuw opstarten vereist Geïnstalleerd Dit bestand is automatisch geïnstalleerd als onderdeel van een recente update. Als u problemen ondervindt, kunt u deze handmatig downloaden en opnieuw installeren.De inhoud van deze pagina is mogelijk automatisch vertaald. Vul het formulier onderaan de pagina in om feedback te geven.
This package contains the Dell System BIOS update. BIOS is a firmware package that is embedded on a small memory chip on the system board. It controls the keyboard, monitor, disk drives, and other devices. This update addresses the Intel Security Advisory INTEL-SA-00115. A security advisory is a statement when a security vulnerability impacts a product, and a remedy is available for the vulnerability.
Aanbevolen
Compatibiliteit controleren
Voer uw productgegevens in om de meest recente driverinformatie voor uw systeem weer te geven.Voer uw Dell servicetag of model in
Wilt u uw product opzoeken? Voer een product-ID in. Meer informatie
Deze driver is niet compatibel
Deze driver is niet van toepassing op het geselecteerde product. Kies een ander product om uw productinformatie voor deze driver opnieuw in te voeren of ga naar de productsupportpagina om alle drivers voor een ander product weer te geven.
Meld u aan bij Windows als beheerder om automatische scanfuncties te gebruiken. Als u al bent aangemeld als beheerder en dit bericht ziet, start dan opnieuw op. Uw systeem wordt beheerd door uw IT-beheerder en de functies kunnen beperkt zijn.
Zoek meer updates. Gebruik SupportAssist om alle nieuwste driverupdates voor uw apparaat te vinden.
Probleemoplossingen en verbeteringen
- Updated CPU microcode to address the Intel Security Advisory INTEL-SA-00115 (CVE-2018-3639 and CVE-2018-3640).
Meer lezenVersie
A11, A11
Releasedatum
20 jul. 2018
Downloadtype
Systeem-BIOS
Categorie
BIOS
Belang
KritiekDell Technologies raadt u sterk aan deze belangrijke update zo spoedig mogelijk uit te voeren. De update bevat essentiële bugfixes en wijzigingen om de functionaliteit, betrouwbaarheid en stabiliteit van uw Dell systeem te verbeteren. De update bevat mogelijk ook beveiligingsoplossingen en andere functieverbeteringen.
Beschikbare bestandsindelingen Belangrijke informatie weergeven:
Bestandsindeling: CPG BIOS-uitvoerbaar bestand voor Windows/DOS
Bestandsnaam: Inspiron_2350_A11.EXE
Bestandsgrootte: 12.74 MB
Dit is een groot bestand. Afhankelijk van uw verbindingssnelheid kan het downloaden enige tijd duren.
Format-omschrijving:
Deze bestandsindeling bestaat uit een uitvoerbaar BIOS-bestand. De universele (Windows/MS-DOS)-indeling kan worden gebruikt om het bestand te installeren vanuit elke Windows of MS DOS-omgeving.
Verifieer de checksum-waarde om de integriteit van uw download te garanderen.
MD5:
c454b153d6d2e6e3840cf9bb1b862ff5
SHA1:
e87d02cba2b81dba94fa30a05ad0b8931292e8a5
SHA-256:
8c7d880609401a1bb800eed2ff2c18b7a15b2e306d727a2bb18fb8be7dd12bac
Door te downloaden accepteert u de voorwaarden van de softwarelicentieovereenkomst van Dell. (in het Engels)
Belangrijke informatie
BIOS updates take no more than 5 minutes to be installed on your system. You can install the updates in the background while using the system.
Geldt voor
DELL Inspiron 2350
Installatie-instructies
Updating the BIOS from Windows
Note 1: Before updating the BIOS, ensure that you suspend BitLocker encryption on a BitLocker-enabled system. If BitLocker is not enabled on your system, you can ignore this step. For information about how to disable BitLocker, see How to Enable or Disable BitLocker with TPM in Windows at support.dell.com.
Note 2: Do not turn off power or interrupt the BIOS update process during the update.
Note 3: Your system requires a restart after installing the BIOS. The restart can be deferred but must be completed to ensure that the update is installed.
Download and Installation
1. Click Download File.
2. Click Save to save the file to your hard drive.
3. Browse to the location where you downloaded the file.
4. Double-click the new file.
5. The system restarts automatically and updates the BIOS at the system startup screen. After the BIOS update is complete, system restarts again.
Updating the BIOS from DOS (Non-Windows users)
Note 1: Before updating the BIOS, ensure that you suspend BitLocker encryption on a BitLocker-enabled system. If it is not enabled on your system, you can ignore this step. For information about how to disable BitLocker, see How to Enable or Disable BitLocker with TPM in Windows at support.dell.com
Note 2: Do not turn off power or interrupt the BIOS update process during the update.
Note 3: Your system requires a restart after installing the BIOS. The restart can be deferred but must be completed to ensure that the update is installed.
Installation
Note: You must provide a bootable USB drive. This executable file does not create the DOS system files.
1. Copy the downloaded file to a bootable USB drive.
2. Power on the system and then Press the F12 key.
3. Select USB Storage Device and boot to the DOS prompt.
4. Run the file by typing following command. For example:
C:\ Inspiron_2350_X.Y.Z.exe
Where C is the drive letter of the USB device where the executable file is located and Inspiron_2350_X.Y.Z.exe is the name of the downloaded file.
The system restarts automatically and updates the BIOS at the system startup screen. After the BIOS update is complete, system restarts again.
Updating the BIOS from DOS with UEFI boot mode enabled (Non-Windows users, Load Legacy Option Disabled)
Note 1: Before updating the BIOS, ensure that you suspend BitLocker encryption on a BitLocker-enabled system. If it is not enabled on your system, you can ignore this step. For information about how to disable BitLocker, see How to Enable or Disable BitLocker with TPM in Windows at support.dell.com
Note 2: Do not turn off the power or interrupt the BIOS update process during the update.
Note 3: Your system requires a restart after installing the BIOS. The restart can be deferred but must be completed to ensure that the update is installed.
Installation
1. Copy the downloaded file to a bootable DOS USB drive.
2. Power on the system and then go to BIOS Setup by pressing the F2 key.
3. Go to General > Boot Sequence > Boot > Boot List Option.
4. Change UEFI to Legacy of Boot List Option.
5. Go to Exit > Save Changes and reboot system.
6. Press F12 and then select USB Storage Device and boot to the DOS prompt.
7. Run the file by typing the file name.
8. The system restarts automatically and updates the BIOS at the system startup screen. After the BIOS update is complete, the system restarts again.
9. Go to BIOS Setup by pressing the F2 key and go to General > Boot Sequence > Boot > Boot List Option.
10. Change Legacy to UEFI Boot Option.
11. Go to Exit > Save Changes and reboot the system.
Note 1: Before updating the BIOS, ensure that you suspend BitLocker encryption on a BitLocker-enabled system. If BitLocker is not enabled on your system, you can ignore this step. For information about how to disable BitLocker, see How to Enable or Disable BitLocker with TPM in Windows at support.dell.com.
Note 2: Do not turn off power or interrupt the BIOS update process during the update.
Note 3: Your system requires a restart after installing the BIOS. The restart can be deferred but must be completed to ensure that the update is installed.
Download and Installation
1. Click Download File.
2. Click Save to save the file to your hard drive.
3. Browse to the location where you downloaded the file.
4. Double-click the new file.
5. The system restarts automatically and updates the BIOS at the system startup screen. After the BIOS update is complete, system restarts again.
Updating the BIOS from DOS (Non-Windows users)
Note 1: Before updating the BIOS, ensure that you suspend BitLocker encryption on a BitLocker-enabled system. If it is not enabled on your system, you can ignore this step. For information about how to disable BitLocker, see How to Enable or Disable BitLocker with TPM in Windows at support.dell.com
Note 2: Do not turn off power or interrupt the BIOS update process during the update.
Note 3: Your system requires a restart after installing the BIOS. The restart can be deferred but must be completed to ensure that the update is installed.
Installation
Note: You must provide a bootable USB drive. This executable file does not create the DOS system files.
1. Copy the downloaded file to a bootable USB drive.
2. Power on the system and then Press the F12 key.
3. Select USB Storage Device and boot to the DOS prompt.
4. Run the file by typing following command. For example:
C:\ Inspiron_2350_X.Y.Z.exe
Where C is the drive letter of the USB device where the executable file is located and Inspiron_2350_X.Y.Z.exe is the name of the downloaded file.
The system restarts automatically and updates the BIOS at the system startup screen. After the BIOS update is complete, system restarts again.
Updating the BIOS from DOS with UEFI boot mode enabled (Non-Windows users, Load Legacy Option Disabled)
Note 1: Before updating the BIOS, ensure that you suspend BitLocker encryption on a BitLocker-enabled system. If it is not enabled on your system, you can ignore this step. For information about how to disable BitLocker, see How to Enable or Disable BitLocker with TPM in Windows at support.dell.com
Note 2: Do not turn off the power or interrupt the BIOS update process during the update.
Note 3: Your system requires a restart after installing the BIOS. The restart can be deferred but must be completed to ensure that the update is installed.
Installation
1. Copy the downloaded file to a bootable DOS USB drive.
2. Power on the system and then go to BIOS Setup by pressing the F2 key.
3. Go to General > Boot Sequence > Boot > Boot List Option.
4. Change UEFI to Legacy of Boot List Option.
5. Go to Exit > Save Changes and reboot system.
6. Press F12 and then select USB Storage Device and boot to the DOS prompt.
7. Run the file by typing the file name.
8. The system restarts automatically and updates the BIOS at the system startup screen. After the BIOS update is complete, the system restarts again.
9. Go to BIOS Setup by pressing the F2 key and go to General > Boot Sequence > Boot > Boot List Option.
10. Change Legacy to UEFI Boot Option.
11. Go to Exit > Save Changes and reboot the system.
Hulp nodig bij BIOS-problemen?
Zoek een oplossing in de Dell gids voor BIOS-problemenHelp en zelfstudies voor drivers
Ga voor meer downloads naar Drivers en downloads. Voor hulp bij het gebruik van de informatie op deze pagina, gaat u naar Hulp en zelfstudies voor drivers.