Do not turn off your computer or disconnect from the power source while updating the BIOS as this could harm your computer. During the update, your computer will restart and you may briefly see a black screen.
Before updating, please read the installation instructions and important information noted below.
Dell Inspiron 5577 System BIOS
Este necesară repornirea Instalat Acest fișier a fost instalat automat ca parte a unei actualizări recente. Dacă întâmpinați orice probleme, puteți descărca și reinstala manual.Conținutul acestei pagini este posibil să fi fost tradus automat. Pentru a furniza feedback, completați formularul din partea de jos a paginii.
This package contains the Dell system BIOS update. BIOS is a firmware that is embedded on a small memory chip on the system board. It controls the keyboard, monitor, disk drives, and other devices. This update addresses the Intel security advisories INTEL-SA-00185 and INTEL-SA-00191. A security advisory is a statement when a product is impacted by a security vulnerability and a remedy is available.
Recomandate
Verificați compatibilitatea
Introduceți detaliile produsului pentru a vedea cele mai recente informații despre driverele sistemului dvs.Introduceți eticheta de service Dell sau modelul
Doriți să vă căutați produsul? Introduceți un identificator de produs. Arătați-mi cum
This driver is not compatible
This driver is not applicable for the selected product. Choose another product to re-enter your product details for this driver or visit the Product Support page to view all drivers for a different product.
Conectați-vă la Windows ca administrator pentru a utiliza scanarea automată. Dacă sunteți deja conectat ca administrator și vedeți acest mesaj, reporniți sistemul. Sistemul dvs. este gestionat de către administratorul IT, iar caracteristicile pot fi limitate.
Găsiți mai multe actualizări. Utilizați SupportAssist pentru a găsi cele mai recente actualizări ale driverelor pentru dispozitivul dvs.
Fixes & Enhancements
-Firmware updates to address security advisory INTEL-SA-00185 (CVE-2018-12188, CVE-2018-12190, CVE-2018-12191, CVE-2018-12192, CVE-2018-12199, CVE-2018-12198, CVE-2018-12200, CVE-2018-12187, CVE-2018-12196, and CVE-2018-12185).
-Firmware updates to address security advisory INTEL-SA-00191(CVE-2018-12201, CVE-2018- 12202, and CVE-2018-12203).
Citiți mai multe-Firmware updates to address security advisory INTEL-SA-00191(CVE-2018-12201, CVE-2018- 12202, and CVE-2018-12203).
Versiune
1.1.2, 1.1.2
Data lansării:
20 mar. 2019
Tip de descărcare
Interfața BIOS
Categorie
BIOS
Importanță
CriticăDell Technologies highly recommends applying this important update as soon as possible. The update contains critical bug fixes and changes to improve functionality, reliability, and stability of your Dell system. It may also include security fixes and other feature enhancements.
Formate disponibile
Format fișier CPG BIOS Executable for Windows/DOS
Nume fișier: 5577112.EXE
Dimensiune fișier: 6.27 MB
Acesta este un fișier mare. În funcție de viteza conexiunii, descărcarea poate dura mai mult timp.
Descriere format:
This file format consists of a BIOS executable file. The Universal (Windows/MS DOS) format can be used to install from any Windows or MS DOS environment.
Pentru a asigura integritatea descărcării, verificați valoarea cifrei de control.
MD5:
044733a8e27d4485899b39609577cad8
SHA1:
8504d1774897674f656daff121447b7caa6ea572
SHA-256:
24d86ef6a4aeaa4d3d0ee609ab53dd32b3d4d24d8cfe1febccdb3933ffa538ef
Prin descărcare, acceptați termenii Dell Software License Agreement.
Se aplică pentru
Dell Inspiron 5577
Instrucțiuni de instalare
Updating the BIOS from Windows
Note 1: Before updating the BIOS, ensure that you suspend BitLocker encryption on a BitLocker-enabled system. If it is not enabled on your system, you can ignore this step. For information about how to disable BitLocker, see How to Enable or Disable BitLocker with TPM in Windows at support.dell.com.
Note 2: Do not turn off the power or interrupt the BIOS update process during the update.
Download and Installation
1. Click Download File, to download the file.
2. Click Save to save the file to your hard drive.
3. Browse to the location where you downloaded the file and double-click the new file.
The system restarts automatically and updates the BIOS at the system startup screen. After the BIOS update is complete, system restarts again.
Updating the BIOS from DOS (Non-Windows users)
Note 1: Before updating the BIOS, ensure that you suspend BitLocker encryption on a BitLocker-enabled system. If it is not enabled on your system, you can ignore this step. For information about how to disable BitLocker, see How to Enable or Disable BitLocker with TPM in Windows at support.dell.com.
Note 2: Do not turn off power or interrupt the BIOS update process during the update.
Installation
Note: You must provide a bootable USB drive. This executable file does not create the DOS system files.
1. Copy the downloaded file to a bootable USB drive.
2. Power on the system and then Press the F12 key.
3. Select USB Storage Device and boot to the DOS prompt.
4. Run the file by typing following command. For example:
C:\ Inspiron_5577_X.Y.Z.exe
Where C is the drive letter of the USB device where the executable file is located and Inspiron_5577_X.Y.Z.exe is the name of the downloaded file.
The system restarts automatically and updates the BIOS at the system startup screen. After the BIOS update is complete, system restarts again.
Updating the BIOS from DOS with UEFI boot mode enabled (Non-Windows users, Load Legacy Option Disabled)
Note 1: Before updating the BIOS, ensure that you suspend BitLocker encryption on a BitLocker-enabled system. If it is not enabled on your system, you can ignore this step. For information about how to disable BitLocker, see How to Enable or Disable BitLocker with TPM in Windows at support.dell.com.
Note 2: Do not turn off the power or interrupt the BIOS update process during the update.
Installation
1. Copy the downloaded file to a bootable DOS USB drive.
2. Power on the system and then go to BIOS Setup by pressing the F2 key.
3. Go to General > Boot Sequence > Boot > Boot List Option.
4. Change UEFI to Legacy of Boot List Option.
5. Go to Exit > Save Changes and reboot system.
6. Press F12 and then select USB Storage Device and boot to the DOS prompt.
7. Run the file by typing the file name.
The system restarts automatically and updates the BIOS at the system startup screen. After the BIOS update is complete, the system restarts again.
8. Go to BIOS Setup by pressing the F2 key and go to General > Boot Sequence > Boot > Boot List Option.
9. Change Legacy to UEFI Boot Option.
10. Go to Exit > Save Changes and reboot the system.
Note 1: Before updating the BIOS, ensure that you suspend BitLocker encryption on a BitLocker-enabled system. If it is not enabled on your system, you can ignore this step. For information about how to disable BitLocker, see How to Enable or Disable BitLocker with TPM in Windows at support.dell.com.
Note 2: Do not turn off the power or interrupt the BIOS update process during the update.
Download and Installation
1. Click Download File, to download the file.
2. Click Save to save the file to your hard drive.
3. Browse to the location where you downloaded the file and double-click the new file.
The system restarts automatically and updates the BIOS at the system startup screen. After the BIOS update is complete, system restarts again.
Updating the BIOS from DOS (Non-Windows users)
Note 1: Before updating the BIOS, ensure that you suspend BitLocker encryption on a BitLocker-enabled system. If it is not enabled on your system, you can ignore this step. For information about how to disable BitLocker, see How to Enable or Disable BitLocker with TPM in Windows at support.dell.com.
Note 2: Do not turn off power or interrupt the BIOS update process during the update.
Installation
Note: You must provide a bootable USB drive. This executable file does not create the DOS system files.
1. Copy the downloaded file to a bootable USB drive.
2. Power on the system and then Press the F12 key.
3. Select USB Storage Device and boot to the DOS prompt.
4. Run the file by typing following command. For example:
C:\ Inspiron_5577_X.Y.Z.exe
Where C is the drive letter of the USB device where the executable file is located and Inspiron_5577_X.Y.Z.exe is the name of the downloaded file.
The system restarts automatically and updates the BIOS at the system startup screen. After the BIOS update is complete, system restarts again.
Updating the BIOS from DOS with UEFI boot mode enabled (Non-Windows users, Load Legacy Option Disabled)
Note 1: Before updating the BIOS, ensure that you suspend BitLocker encryption on a BitLocker-enabled system. If it is not enabled on your system, you can ignore this step. For information about how to disable BitLocker, see How to Enable or Disable BitLocker with TPM in Windows at support.dell.com.
Note 2: Do not turn off the power or interrupt the BIOS update process during the update.
Installation
1. Copy the downloaded file to a bootable DOS USB drive.
2. Power on the system and then go to BIOS Setup by pressing the F2 key.
3. Go to General > Boot Sequence > Boot > Boot List Option.
4. Change UEFI to Legacy of Boot List Option.
5. Go to Exit > Save Changes and reboot system.
6. Press F12 and then select USB Storage Device and boot to the DOS prompt.
7. Run the file by typing the file name.
The system restarts automatically and updates the BIOS at the system startup screen. After the BIOS update is complete, the system restarts again.
8. Go to BIOS Setup by pressing the F2 key and go to General > Boot Sequence > Boot > Boot List Option.
9. Change Legacy to UEFI Boot Option.
10. Go to Exit > Save Changes and reboot the system.
Aveți nevoie de ajutor cu problemele legate de BIOS?
Găsiți o soluție în ghidul de depanare a BIOS-ului de la DellAjutor și tutoriale pentru drivere
Pentru mai multe descărcări, accesați Drivere și descărcări. Pentru ajutor privind utilizarea informațiilor de pe această pagină, accesați Tutoriale și ajutor pentru drivere.