Do not turn off your computer or disconnect from the power source while updating the BIOS as this could harm your computer. During the update, your computer will restart and you may briefly see a black screen.
Before updating, please read the installation instructions and important information noted below.
Dell Inspiron 3650 and 3250 System BIOS
Restart required Takılı Bu dosya son güncellemenin bir parçası olarak otomatik olarak yüklendi. Herhangi bir sorun yaşıyorsanız, manuel olarak indirip yeniden yükleyebilirsiniz.Bu sayfa içeriği otomatik olarak çevrilmiş olabilir. Geri bildirim sağlamak için sayfanın en altındaki formu doldurun.
This package contains the Dell system BIOS update. BIOS is a firmware that is embedded on a small memory chip on the system board. It controls the keyboard, monitor, disk drives, and other devices. The update addresses the Intel security advisories INTEL-SA-00213 and INTEL-SA-00233. A security advisory is an official statement when a product is impacted by a security vulnerability and a remedy is available.
Önerilen
Uyumluluğu kontrol edin
Sisteminize yönelik en son sürücü bilgilerini görüntülemek için lütfen ürün ayrıntılarınızı girinDell Servis Etiketinizi veya modelinizi girin
Ürününüzü aramak mı istiyorsunuz? Bir ürün tanımlayıcısı girin. Nasıl yapılacağını göster
Bu sürücü uyumlu değil
Bu sürücü, seçilen ürün için geçerli değildir. Ürün ayrıntılarınızı yeniden girmek için başka bir ürün seçin veya farklı bir ürüne yönelik tüm sürücüleri görüntülemek için Ürün Desteği sayfasını ziyaret edin.
Otomatik taramayı kullanmak için Windows'da yönetici olarak oturum açın. Zaten yönetici olarak oturum açtıysanız ve bu mesajı görüyorsanız lütfen yeniden başlatın. Sisteminiz BT yöneticiniz tarafından yönetiliyor ve özellikler sınırlı olabilir.
Daha fazla güncelleme bulun. SupportAssist'i kullanarak aygıtınız için en son sürücü güncellemelerini bulun.
Fixes & Enhancements
- Firmware updates to address security advisories INTEL-SA-00233 (CVE-2018-12126, CVE-2018-12127, CVE-2018-12130 and CVE-2019-11091).
- Firmware updates to address security advisory INTEL-SA-00213 (CVE-2019-0086, CVE-2019-0091 and CVE-2019-0093).
Read More- Firmware updates to address security advisory INTEL-SA-00213 (CVE-2019-0086, CVE-2019-0091 and CVE-2019-0093).
Version
3.9.0, 3.9.0
Sürüm tarihi
31 Tem 2019
İndirme Türü
Sistem BIOS
Kategori
BIOS
Önem
KritikDell Technologies, bu önemli güncellemeyi mümkün olan en kısa sürede uygulamanızı kesinlikle önerir. Bu güncelleme, Dell sisteminizin işlevselliğini, güvenilirliğini ve kararlılığını iyileştirmeye yönelik kritik hata düzeltmeleri ve değişiklikler içerir. Ayrıca güvenlik düzeltmeleri ve başka özellik iyileştirmeleri de içerebilir.
Kullanılabilir biçimler View Important Information
Dosya Biçimi: Windows/DOS için CPG BIOS Yürütülebilir Dosyası
Dosya Adı: Inspiron_3650_3250_Vostro_3650_3653_3250_3.9.0.exe
Dosya Boyutu: 7.21 MB
Bu büyük bir dosyadır. Bağlantı hızınıza bağlı olarak indirme işlemi biraz zaman alabilir.
Biçim Açıklaması:
This file format consists of a BIOS executable file. The Universal (Windows/MS DOS) format can be used to install from any Windows or MS DOS environment.
İndirme işleminizin bütünlüğünü sağlamak için lütfen sağlama toplamı değerini doğrulayın.
MD5:
e59a5cd2a7a1ad04e85c1905c0252940
SHA1:
753a408c18d97689a2e14f1b915c34b6d5c66471
SHA-256:
685aaf34ea7ad974c82ae850ff50386d5a43a0f3192bb9871cf71b8ffd1fd646
İndirdiğinizde, Dell Software Lisans Sözleşmesi’nin koşullarını kabul etmiş olursunuz.
Important Information
It is recommended that you do not power off the system until the process of updating the BIOS has completed.
Şunlar için geçerlidir:
Dell Inspiron 3250
Dell Inspiron 3650
Kurulum talimatları
Run the BIOS update utility from Windows environment.
Note 1: Before updating the BIOS, ensure that you suspend BitLocker encryption on a BitLocker-enabled system. If it is not enabled on your system, you can ignore this step. For information about how to disable BitLocker, see How to Enable or Disable BitLocker with TPM in Windows at support.dell.com.
Note 2: Do not turn off the power or interrupt the BIOS update process during the update.
Download and Installation
1. Click Download File.
2. Click Save to save the file to your hard drive
3. Browse to the location where you downloaded the file and double-click the new file.
The system restarts automatically and updates the BIOS at the system startup screen. After the BIOS update is complete, system restarts again.
Run the BIOS update utility from DOS environment (Non-Windows users)
Note 1: Before updating the BIOS, ensure that you suspend BitLocker encryption on a BitLocker-enabled system. If it is not enabled on your system, you can ignore this step. For information about how to disable BitLocker, see How to Enable or Disable BitLocker with TPM in Windows at support.dell.com.
Note 2: Do not turn off the power or interrupt the BIOS update process during the update.
Installation
Note: You must provide a bootable USB drive. This executable file does not create the DOS system files.
1. Copy the downloaded file to a bootable USB drive.
2. Power on the system and then Press the F12 key.
3. Select USB Storage Device and boot to the DOS prompt.
4. Run the file by typing following command. For example:
C:\ Inspiron_ 3650_X.Y.Z.exe
Where C is the drive letter of the USB device where the executable file is located and Inspiron_ 3650_X.Y.Z.exe is the name of the downloaded file.
The system restarts automatically and updates the BIOS at the system startup screen. After the BIOS update is complete, system restarts again.
Updating the BIOS from a DOS environment with UEFI boot mode (Non-Windows users, Load Legacy Option Disabled)
Note 1: Before updating the BIOS, ensure that you suspend BitLocker encryption on a BitLocker-enabled system. If BitLocker is not enabled on your system, you can ignore this step.
Note 2: Do not turn off the power or interrupt the BIOS update process during the update.
1. Copy the downloaded file to a bootable DOS USB drive.
2. Power on the system and then go to BIOS Setup by pressing the F2 key.
3. Go to General > Boot Sequence > Boot > Boot List Option.
4. Change UEFI to Legacy of Boot List Option.
5. Go to Exit > Save Changes and reboot system.
6. Press F12 and then select USB Storage Device and boot to the DOS prompt.
7. Run the file by typing the file name.
The system restarts automatically and updates the BIOS at the system startup screen. After the BIOS update is complete, the system restarts again.
8. Go to BIOS Setup by pressing the F2 key and go to General > Boot Sequence > Boot > Boot List Option.
9. Change Legacy to UEFI Boot Option.
10. Go to Exit > Save Changes and reboot the system.
Note 1: Before updating the BIOS, ensure that you suspend BitLocker encryption on a BitLocker-enabled system. If it is not enabled on your system, you can ignore this step. For information about how to disable BitLocker, see How to Enable or Disable BitLocker with TPM in Windows at support.dell.com.
Note 2: Do not turn off the power or interrupt the BIOS update process during the update.
Download and Installation
1. Click Download File.
2. Click Save to save the file to your hard drive
3. Browse to the location where you downloaded the file and double-click the new file.
The system restarts automatically and updates the BIOS at the system startup screen. After the BIOS update is complete, system restarts again.
Run the BIOS update utility from DOS environment (Non-Windows users)
Note 1: Before updating the BIOS, ensure that you suspend BitLocker encryption on a BitLocker-enabled system. If it is not enabled on your system, you can ignore this step. For information about how to disable BitLocker, see How to Enable or Disable BitLocker with TPM in Windows at support.dell.com.
Note 2: Do not turn off the power or interrupt the BIOS update process during the update.
Installation
Note: You must provide a bootable USB drive. This executable file does not create the DOS system files.
1. Copy the downloaded file to a bootable USB drive.
2. Power on the system and then Press the F12 key.
3. Select USB Storage Device and boot to the DOS prompt.
4. Run the file by typing following command. For example:
C:\ Inspiron_ 3650_X.Y.Z.exe
Where C is the drive letter of the USB device where the executable file is located and Inspiron_ 3650_X.Y.Z.exe is the name of the downloaded file.
The system restarts automatically and updates the BIOS at the system startup screen. After the BIOS update is complete, system restarts again.
Updating the BIOS from a DOS environment with UEFI boot mode (Non-Windows users, Load Legacy Option Disabled)
Note 1: Before updating the BIOS, ensure that you suspend BitLocker encryption on a BitLocker-enabled system. If BitLocker is not enabled on your system, you can ignore this step.
Note 2: Do not turn off the power or interrupt the BIOS update process during the update.
1. Copy the downloaded file to a bootable DOS USB drive.
2. Power on the system and then go to BIOS Setup by pressing the F2 key.
3. Go to General > Boot Sequence > Boot > Boot List Option.
4. Change UEFI to Legacy of Boot List Option.
5. Go to Exit > Save Changes and reboot system.
6. Press F12 and then select USB Storage Device and boot to the DOS prompt.
7. Run the file by typing the file name.
The system restarts automatically and updates the BIOS at the system startup screen. After the BIOS update is complete, the system restarts again.
8. Go to BIOS Setup by pressing the F2 key and go to General > Boot Sequence > Boot > Boot List Option.
9. Change Legacy to UEFI Boot Option.
10. Go to Exit > Save Changes and reboot the system.
BIOS sorunlarıyla ilgili yardıma mı ihtiyacınız var?
Dell'in BIOS sorun giderme kılavuzundan bir çözüm bulunSürücülerle ilgili yardım ve öğreticiler
Daha fazla indirme için bkz. Sürücüler ve indirmeler. Bu sayfadaki bilgileri kullanmayla ilgili yardım almak için lütfen Sürücü Yardımı ve Öğretici Videoları bölümünü ziyaret edin.