下載檔案
檔案格式: 此檔案格式內含純文字,可使用標準文字編輯器予以檢視。
檔案名稱: EndUser LicenseAgreementType S_Rev.040512.txt
檔案大小: 11.4 KB
為了確保下載的完整性,請驗證總和檢查值。
MD5: c2ffe409366d225552ac6ed58f206b58
SHA1: 88522584d2ed8711c12c71ae9e569116a26e7b0a
SHA-256: b85aae437264a3f053c9efec6b47fa1ba6610de28b749a06c2fec3dfc87bf333
檔案格式: 此格式包含安裝軟體所需的 gnu zip 檔案。
檔案名稱: KV289_RMg5update_03.70.06.tar.gz
檔案大小: 122.12 MB
為了確保下載的完整性,請驗證總和檢查值。
MD5: 1c1f22c0cff9a3e2fb37d7b52a3eacea
SHA1: 88d2931deb6f61326b5da5b9816d58fe1aaaad0b
SHA-256: fa307b314e8c900a48944c1f2bd8e5fe5234c333007b1eb0ebe75d5c1c00fbe1
檔案格式: 此檔案格式內含純文字,可使用標準文字編輯器予以檢視。
檔案名稱: DSS9000_rack_fw_3.70.06_readme.txt
檔案大小: 1.68 KB
為了確保下載的完整性,請驗證總和檢查值。
MD5: 35b6c13d670085925aada661513003ce
SHA1: 00597c86c141d47205e2c6cf150edd2122b7f119
SHA-256: d1a287b95a22888775d54aef9d4fbe213b46f5adccd91d7a833cc4666772419f
修復及強化
Fixes -
Not Applicable
Enhancements -
Not Applicable
安裝指示
If you are updating the Pantera firmware over the Odin firmware, you need to follow below given steps.
Update via MC CLI
First update the MC firmware via MC CLI using folloing command.
load -source tftp:///MC_OP.d7 -install /
It will take few minutes to update and may report a failure.
Depending on the MC's current active partition the older Odin
firmware or the newer Pantera firmware will boot after update.
Note:
1) If the MC does not reboot automatically, DO NOT
REBOOT IT as this will cause data corruption.
- recovery from a corrupt state will require a serial console connection and performing a UBOOT recovery.
2) During this step all MC config files (mc.conf and manufacturing.conf) will get lost and newer firware will start with the default config files and MC is configured in DHCP.
Now you need to again update the same MC Pantera firmware via MC CLI using folloing command.
load -source tftp:///MC_OP.d7 -install /
After updating MC twice, you can now use the MC with Pantera firmware.
Update via UBOOT
Power on the MC Board and press "Enter" to enter in boot mode
First update the existing uboot using following command.
G5MC> util recover -i uboot1 -f /MC_BL.bin
On next auto reboot, again go into the boot mode by pressing "Enter".
Now update the MC firmware using following command.
G5MC> util recover -f /MC_OP.d7
It will upgrade MC with new Image.