How to perform interface range commands on 7000, 8000, 8100, M6220, M6348, M8024-K N2000, N3000 and N4000 series switches

Article Summary: This article explains how to configure multiple interfaces at the same time.

 

To configure multiple interfaces at the same time, you have to go into an interface range command.

Run the following commands to enter a range of interfaces.

console>enable

console#configure

For consecutive ports, the following example uses Gigabit Ethernet ports 1-5 on Unit 1

console(config)#interface range gi1/0/1-5

For non-consecutive ports, the following example uses Gigabit Ethernet ports 48 on Unit 1 and 2

console(config)#interface range gi1/0/48,gi2/0/48

 

Below is an example to configure the consecutive ports 1 through 5, as well as 8 and 9.

console(config)#interface range gi1/0/1-5,gi1/0/8,gi1/0/9