NetWorker: Båndoperasjoner mislykkes med feilen: les åpen feil: kommandoen ble fullført (stasjonsstatus er MEDIEINNLASTING ELLER UTMATING MISLYKTES) 

Summary: Under båndmerking eller monteringsoperasjoner i NetWorker kan prosessen mislykkes med feilmeldingen: Les åpen feilmelding: kommandoen ble fullført (stasjonsstatus er MEDIEINNLASTING ELLER UTMATING MISLYKTES). Dette indikerer et problem med at båndstasjonen laster eller utløser mediet, ofte forårsaket av problemer med maskinvare eller båndmedier. ...

This article applies to This article does not apply to This article is not tied to any specific product. Not all product versions are identified in this article.
Check out other resources

Symptoms

  • Merking eller montering av båndvolumer mislykkes med feilmeldingen:
    read open error: command completed successfully (drive status is MEDIA LOAD OR EJECT FAILED)

  • Daemon logger (daemon.raw) viser følgende advarsler og feil under merking eller monteringsoperasjoner:
    NSR info media warning: <device_name> opening: MEDIA LOAD OR EJECT FAILED  
nsrd NSR info media warning: <device_name> moving: read open error: command completed successfully (drive status is MEDIA LOAD OR EJECT FAILED)  
nsrd NSR warning Status update: operation 'SNMD_DEVOP_DEACTIVATE', instance '356', on device '<device_name>' has completed abnormally with status 'DEV_OP_ERROR'.
  • Statuskontroll av båndstasjon ved hjelp av mt Kommandoen viser datafeil som angir mulige maskinvare- eller medieproblemer:

    mt -f <device_name> status  
<device_name>:  
Current Status: Data error (cyclic redundancy check).

        default blocksize = 65536  
        maximum blocksize = 524288  
        minimum blocksize = 1  
        MaximumPartitionCount = 0  
        EOTWarningZoneSize = 0  
        Error Correction Enabled  
        CompressionEnabled  
        Features:  
                Performs SHORT erase operation  
                Performs LONG erase operation  
                Performs IMMEDIATE erase operation  
                Can report maximum tape capacity  
                Can report amount of tape remaining  
                Support FIXED block length mode  
                Support VARIABLE block length mode  
                Returns errors on write if tape is write-protected  
                Supports hardware data compression  
                Can provide current absolute device block address  
                Can provide current logical block address and partition  
                Can physically load and/or unload tape  
                Support PREVENT / ALLOW Media Removal  
                Performs IMMEDIATE rewind operations  
                Allows Setting FIXED LENGTH or VARIABLE block sizes  
                Performs IMMEDIATE Load / Unload operations  
                Allows hardware data compression to be enabled/disabled  
                Can position tape to an absolute physical block  
                Can position tape to a logical block (and partition)  
                Can position tape to END of RECORDED DATA  
                Can perform tape record positioning (backwards/forwards)  
                Can perform tape file positioning (backwards/forwards)  
                Can move backwards across records or filemarks or setmarks  
                Can write FILEMARKS  
                Performs IMMEDIATE tape mark write operations  
operation status on <device_name> failed: Data error (cyclic redundancy check).  
(Investigate bad media or hardware)
  • Operativsystemlogger rapporterer advarsler relatert til feil for medieinnlasting eller utmating på båndenheten, for eksempel:
    NetWorker media: (warning) rd=dcp-nwsn1.rnp.local:\\.\Tape4 opening: MEDIA LOAD OR EJECT FAILED

Cause

Som feilen antyder, Maskinvare (båndstasjon) eller båndmedieproblem.

Resolution

Bekreft at problemet skyldes en bestemt båndstasjon eller kontrollbane ved å bytte stasjoner. Maskinvareleverandøren kan gi bedre hjelp til hvordan man skal håndtere denne situasjonen.

Affected Products

NetWorker Family
Article Properties
Article Number: 000334637
Article Type: Solution
Last Modified: 18 Jul 2025
Version:  1
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.