由于端口组配置文件错误，Dell Networking OS10 S5200 或 S4148U 端口未启动
Summary: 已插入已知良好的线缆和收发器，但端口未启动。已验证端口未关机。为什么端口没有出现？
This article applies to
This article does not apply to
This article is not tied to any specific product.
Not all product versions are identified in this article.
Instructions
交换机型号
S4148U
和 S5200
软件版本
OS10
如何更改端口组模式
端口组可能未配置为以指定速度协商。
| 命令 | 描述 |
|---|---|
show port-group |
这将显示所有端口组及其当前的配置方式。 |
记下要修改
的端口组编号 我们正在寻找端口 56。
来自 S5200 的示例：
OS10# show port-group
Port-group Mode Ports FEM
port-group1/1/1 Eth 25g-4x 1 2 3 4 -
port-group1/1/2 Eth 10g-4x 5 6 7 8 -
port-group1/1/3 Eth 10g-4x 9 10 11 12 -
port-group1/1/4 Eth 10g-4x 13 14 15 16 -
port-group1/1/5 Eth 25g-4x 17 18 19 20 -
port-group1/1/6 Eth 25g-4x 21 22 23 24 -
port-group1/1/7 Eth 25g-4x 25 26 27 28 -
port-group1/1/8 Eth 25g-4x 29 30 31 32 -
port-group1/1/9 Eth 25g-4x 33 34 35 36 -
port-group1/1/10 Eth 10g-4x 37 38 39 40 -
port-group1/1/11 Eth 25g-4x 41 42 43 44 -
port-group1/1/12 Eth 25g-4x 45 46 47 48 -
port-group1/1/13 Eth 40g-2x 49 50 -
port-group1/1/14 Eth 40g-2x 51 52 -
port-group1/1/15 Eth 100g-1x 53 -
port-group1/1/16 Eth 100g-1x 54 -
port-group1/1/17 Eth 100g-1x 55 -
port-group1/1/18 Eth 100g-1x 56 -
来自 S4148U 的示例：
OS10# show port-group Port-group Mode Ports FEM port-group1/1/1 Eth 10g-4x 1 2 3 4 - port-group1/1/2 FC 16g-2x 5 6 7 8 - port-group1/1/3 FC 16g-2x 9 10 11 12 - port-group1/1/4 FC 16g-2x 13 14 15 16 - port-group1/1/5 FC 16g-2x 17 18 19 20 - port-group1/1/6 Eth 10g-4x 21 22 23 24 - port-group1/1/7 Eth 100g-1x 25 - port-group1/1/8 Eth 40g-1x 26 - port-group1/1/9 Eth 100g-1x 29 - port-group1/1/10 Eth 40g-1x 30 -
示例：
| 命令 | 描述 |
|---|---|
OS10# show port-group |
这将显示所有端口组及其当前的配置方式。 |
OS10(config)# port-group 1/1/18 |
选择要修改的端口 |
OS10(conf-pg-1/1/18)# mode eth 40g-1x |
指定要设置端口的速度 |
确认：
<165>1 2019-09-11T23:21:00.470567+00:00 S5248F-ON-U24 dn_ifm 852 - - Node.1-Unit.1:PRI [event], Dell EMC (OS10) %IFM_ASTATE_UP: Interface admin state up :ethernet1/1/56:1
验证端口组是否已更改：
OS10# show port-group
Port-group Mode Ports FEM
port-group1/1/1 Eth 25g-4x 1 2 3 4 -
port-group1/1/2 Eth 10g-4x 5 6 7 8 -
port-group1/1/3 Eth 10g-4x 9 10 11 12 -
port-group1/1/4 Eth 10g-4x 13 14 15 16 -
port-group1/1/5 Eth 25g-4x 17 18 19 20 -
port-group1/1/6 Eth 25g-4x 21 22 23 24 -
port-group1/1/7 Eth 25g-4x 25 26 27 28 -
port-group1/1/8 Eth 25g-4x 29 30 31 32 -
port-group1/1/9 Eth 25g-4x 33 34 35 36 -
port-group1/1/10 Eth 10g-4x 37 38 39 40 -
port-group1/1/11 Eth 25g-4x 41 42 43 44 -
port-group1/1/12 Eth 25g-4x 45 46 47 48 -
port-group1/1/13 Eth 40g-2x 49 50 -
port-group1/1/14 Eth 40g-2x 51 52 -
port-group1/1/15 Eth 100g-1x 53 -
port-group1/1/16 Eth 100g-1x 54 -
port-group1/1/17 Eth 100g-1x 55 -
port-group1/1/18 Eth 40g-1x 56 -
软件补丁
按设计运行
Affected Products
PowerSwitch S4112F-ON/S4112T-ON, PowerSwitch S4148F-ON/S4148T-ON/S4148FE-ON, PowerSwitch S4148U-ON, PowerSwitch S5212F-ON, PowerSwitch S5224F-ON, PowerSwitch S5248F-ONArticle Properties
Article Number: 000128222
Article Type: How To
Last Modified: 26 Nov 2025
Version: 8
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.