Connectrix-Brocade B series: How to configure the Fabric name

Summary: This KB involves the steps of how to configure the Fabric name in the Brocade B series switch.

This article applies to This article does not apply to This article is not tied to any specific product. Not all product versions are identified in this article.

Instructions

The following considerations apply to fabric naming:

  • Each name must be unique for each logical switch within a chassis; duplicate fabric names are not allowed.
  • A fabric name can be from 1 through 128 alphanumeric characters (a-z, 0–9).
  • All switches in a logical fabric must be running Fabric OS v7.2.0 or later. Switches running earlier versions of the firmware can co-exist in the fabric, but do not show the fabric name details.
  • You must have admin permissions to configure the fabric name.

Configuring the Fabric Name:
To set and display the fabric name, use the "#fabricname --set" command.

switch:admin> fabricname --set myfabric@1

Using the "fabricName --set" command without a fabric name takes the existing fabric name and synchronizes it across the entire fabric. An error message displays if no name is configured.

To set a fabric name that includes spaces, enclose the fabric name in quotes.

switch:admin> fabricname --set "my new fabric"
Fabric Name is Set to my new fabric.

To set a fabric name that includes special meta-characters or spaces, enclose the fabric name in single quotes.

switch:admin> fabricname --set 'red fabric $$'
NOTE:
  1. To display the fabric name:
    fabricname --show
  2. To clear the fabric name, use the command:
    fabricName --clear

 

Additional Information

Affected Products

Connectrix B-Series
Article Properties
Article Number: 000223812
Article Type: How To
Last Modified: 11 Jun 2025
Version:  2
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.