Dell Networking - Configuring Source Interface for SCP Protocol on OS10

Summary: The OS10 switch typically uses the IP address of the local interface associated with the default or static route as the source IP when transferring configuration files to a remote server. There may be scenarios where it is required to use a different configured IP address as the source when sending files through the SCP protocol. ...

This article applies to This article does not apply to This article is not tied to any specific product. Not all product versions are identified in this article.
Check out other resources

Instructions

This feature is supported starting from Firmware Version 10.6.0.2 release and is in all subsequent releases.

 

Use this command to configure the source IP address for outgoing SCP packets when transferring files using the SCP protocol.

 

 

ip scp source-interface vlan 10

 

Parameters: Specify the interface information.

 

 

OS10(config)# ip scp source-interface
  ethernet                 Ethernet interface type
  loopback                 Loopback interface type
  mgmt                     Management interface type
  port-channel             Port-channel interface type
  vlan                     Vlan interface type

 

The no form of this command disables the configured source interface.

 

OS10(config)# no ip scp source-interface

 

Article Properties
Article Number: 000344871
Article Type: How To
Last Modified: 15 Jul 2025
Version:  1
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.