Connectrix serie MDS: Modulo FC spento a causa del codice errore di sistema "0x42630007 mauler obt bist failure"
Summary: L'errore hardware viene rilevato dal test BIST (Built-In Self Test) su uno degli ASIC F16
Symptoms
Errore BIST (Built-In Self Test) riscontrato sul modulo blade della porta.`show module`
Mod Ports Module-Type Model Status
--- ----- ----------------------------------- ------------------ ----------
8 48 2/4/8/10/16 Gbps Advanced FC Module DS-X9448-768K9 powered-dn
`show module internal exceptionlog module 8`
Module Slot Number: 8
Device Id : 204
Device Name : F16 Generic Driver
Device Errorcode : 0xccc01400
Device ID : 204 (0xcc)
Device Instance : 01 (0x01)
Dev Type (HW/SW) : 04 (0x04)
ErrNum (devInfo) : 00 (0x00)
System Errorcode : 0x42630007 mauler obt bist failure
Error Type : Minor error
PhyPortLayer : Fibre Channel
Port(s) Affected : fc8/9-16
Error Description : hardware init failure
DSAP : 0 (0x0)
UUID : 1129 (0x469)
Time : Fri Jun 26 01:05:56 2020
(Ticks: 5EF59044 jiffies)
Mod Power-Status Reason
--- ------------ ---------------------------
8 powered-dn Reset (powered-down) because module does not boot
show logging log:
2020 Jun 26 01:04:06 CMISAN-10 %MODULE-2-MOD_SOMEPORTS_FAILED: Module 8 (Serial number: XXXXXXXXXXX) reported failure on ports fc8/9-16 (Fibre Channel) due to mauler obt bist failure in device DEV_F16_CMN (device error 0xccc01400)
2020 Jun 26 01:05:01 CMISAN-10 %PORT-5-MODULE_BRINGUP_NOT_ALLOWED: Not allowing module 8 to come up for reason: Device Name:[0xC4] Instance:[38] Error Type:[diag error] code:[0] (0xcc426300)
Cause
Il BIST (Built-In Self Test) fa parte del POST (Power On Self Test). BIST è fondamentalmente un test diagnostico che ha lo scopo di rilevare i guasti dell hardware. I diversi switch che fanno parte della piattaforma MDS supportano un intero set di test diagnostici, incluso BIST.
Quando un chip viene danneggiato, di conseguenza il BIST fallisce. Si tratta di un problema con un guasto hardware su uno degli ASIC F16 all'interno del modulo blade della porta.
Nel caso precedente, il test BIST non riesce per uno degli ASIC responsabili delle porte (9-16).
Resolution
Il modulo deve essere sostituito in quanto si tratta di un guasto ASIC hardware.