Dell EMC Unity:在 Unity 端口上配置 LACP 的交换机要求

Summary: Dell EMC Unity:在 Unity 端口上配置 LACP 的交换机要求

This article applies to This article does not apply to This article is not tied to any specific product. Not all product versions are identified in this article.

Instructions

本知识库文章介绍在 Unity 端口上使用链路聚合 LACP 时的交换机要求:

如果 Unity 端口连接到 不同的网络交换机,则应将连接到这些端口的所有交换机端口配置为立即从 阻塞模式 切换到 转发模式 ,并且在接口启动时不传递侦听和学习生成树状态。在 Cisco 交换机上,这意味着您必须为连接到 Unity 端口的每个交换机端口启用 portfast 功能 ,以保证交换机转发启用物理墨水时存储系统生成的以太网帧。您可以在 端口到端口的基础上启用 portfast 功能。启用时,portfast 变量会导致端口立即从阻塞模式切换到转发模式。请勿在交换机到交换机连接上使用 portfast

Affected Products

Dell EMC Unity Family

Products

Dell Unity 300, Dell EMC Unity 300F, Dell EMC Unity 400, Dell EMC Unity 400F, Dell EMC Unity 500, Dell EMC Unity 500F, Dell EMC Unity 600, Dell EMC Unity 600F, Dell EMC Unity Family |Dell EMC Unity All Flash, Dell EMC Unity Family
Article Properties
Article Number: 000022593
Article Type: How To
Last Modified: 22 Oct 2025
Version:  6
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.