CloudBoost：檢查 NTP 組態

Summary: 本文說明如何檢查 CloudBoost 的 NTP 設定。

This article applies to This article does not apply to This article is not tied to any specific product. Not all product versions are identified in this article.
Check out other resources

Instructions

檢查 NTP 設定對於 CloudBoost 內時鐘偏差敏感的服務至關重要。
 
可在 CloudBoost 命令列 （CLI） 中手動檢查 NTP 設定：
  1. 以系統管理員使用者身分登入 CloudBoost CLI。
  2. 執行命令「diagnostics ntpcheck」。
CloudBoost 接著會驗證 NTP 設定，並嘗試進行同步。
 
有關 CloudBoost NTP 設定的詳細資料，也可以執行「diagnostics ntpcheck advanced」。
 
範例：
admin@mag-fs> diagnostics ntpcheck advanced

NTP query details
=================
associd=0 status=c011 leap_alarm, sync_unspec, 1 event, freq_not_set,
version="ntpd 4.2.6p5@1.2349-o Mon Apr 13 13:39:46 UTC 2015 (1)",
processor="x86_64", system="Linux/3.16.0-59-generic", leap=11,
stratum=16, precision=-22, rootdelay=0.000, rootdisp=22443.660,
refid=INIT, reftime=00000000.00000000  Mon, Jan  1 1900  0:00:00.000,
clock=de35fe44.4214ed43  Tue, Feb 20 2018  1:54:12.258, peer=0, tc=3,
mintc=3, offset=0.000, frequency=0.000, sys_jitter=0.000,
clk_jitter=0.000, clk_wander=0.000

remote           refid      st t when poll reach   delay   offset  jitter
==============================================================================
<IP_ADDRESS>   .INIT.       16 u    - 1024    0    0.000    0.000   0.000

Additional Information

“ntpcheck' 命令僅適用於 CloudBoost 2.1.x 及更高版本。

Affected Products

CloudBoost, CloudBoost Virtual Appliance
Article Properties
Article Number: 000010806
Article Type: How To
Last Modified: 11 Jun 2026
Version:  5
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.