ECS：迁移的剪辑无法读取 - 错误代码：达到最大 C-Clip 大小

Summary: 无法读取已从 Centera 迁移到 ECS 的剪辑，因为出现错误 最大剪辑大小

This article applies to This article does not apply to This article is not tied to any specific product. Not all product versions are identified in this article.
Check out other resources

Symptoms

从 Centera 迁移到已从 Centera 迁移到 ECS

的 CAS 迁移无法读取并引发错误：达到的最大 C-Clip 大小，代码：-10026

ECS 上恢复失败的示例： 
java -jar /home/filepool/bin/CenteraExerciser.jar  -address xx.xx.xx.xx?casuser.pea -order ro -clipfile file
Starting restore of clips and blobs to cluster...
FPClip::CheckCDFSizeEstimate()<FPTag::BlobWrite(stream,2)<FPTag_BlobWrite(-,-,0)

com.filepool.fplibrary.FPLibraryException: Maximum C-Clip size reached
        at com.filepool.fplibrary.FPTag.BlobWrite(Unknown Source)
        at com.filepool.fplibrary.FPTag.BlobWrite(Unknown Source)
        at com.emc.centera.apiengine.core.CenteraSDK.storeRAW(CenteraSDK.java:2150)
        at com.emc.centera.centeraexerciser.utils.RawOpenThread.run(RawOpenThread.java:215)
ERROR: Writing blob (com.filepool.fplibrary.FPTag@1cd296b.BlobWrite(java.io.FileInputStream@5a7159)) - com.filepool.fplibrary.FPLibraryException: Maximum C-Clip size reached, code: -10026 [Thread-1] CenteraSDK.java:2169 at 2019-05-07 17:41:06,757
**** RawOpen(s) finished ****

Test has finished with 1 errors

Test failed

Cause

Centera 无法将超过 100 MB 的固定夹迁移到 ECS。

这是根据设计，它是 CAS SDK 行为，当 CDF 超过 100 MB 时停止获取附加标记。虽然在 Centera 上原始读取成功，但 ECS 上的文件读取会失败。

Resolution

剪辑必须直接从应用程序写入 Centera，然后再次迁移到 ECS。这将生成新的剪辑 ID。

必须在客户应用程序数据库上更新新剪辑。它可能必须使用以前的剪辑 ID 进行存储，这可能会导致读取错误。

Affected Products

ECS Appliance

Products

ECS Appliance
Article Properties
Article Number: 000050451
Article Type: Solution
Last Modified: 22 Feb 2023
Version:  3
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.