Alert: Enclosure Temperature Sensor has been swapped

This article applies to This article does not apply to This article is not tied to any specific product. Not all product versions are identified in this article.
Check out other resources

Instructions

This informative alert is reporting that the enclosure temperature sensor has been swapped.  This message will typically occur if the enclosure IO module or power supply component has been removed and either replaced or re-inserted. 
To clear the swap alert in Dell Storage Manager:
 
  1.  Click Storage Viewer (lower left corner)
  2. Select a Storage Center
  3. Click Hardware tab
  4. Expand Enclosures and enclosure listed in the alert
  5. Select Temperature Sensors
  6. Right click on the sensor that shows Swap Detected Yes and choose Request Swap Clear
If this alert is generated and you are not aware of any maintenance on the array it is recommended to perform the ‘Request Swap Clear’ process above.  If the alert returns, contact Dell Storage support.

Affected Products

Compellent (SC, SCv & FS Series), Dell Storage SCv2000, Dell Storage SCv2020, Dell Storage SCv2080, Dell Storage SC9000
Article Properties
Article Number: 000122203
Article Type: How To
Last Modified: 21 Feb 2021
Version:  3
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.