在部队10交换机上强行为 DAC (双轴) 电缆提供10链路连接。
Summary: 如何解决与 DAC (双轴) 电缆的连接问题。
This article applies to
This article does not apply to
This article is not tied to any specific product.
Not all product versions are identified in this article.
Symptoms
文章摘要: 本文介绍了如何使用 DAC (双轴) 电缆解决连接问题。
使用 DAC (直接连接的铜线 (也称为双轴) 电缆时, 如果不使用 cr4 自动协商, 您可能会遇到链路连接问题。通过启用 cr4 自动协商 (默认情况下未启用) 来解决此问题。下面的示例显示了如何在单元0上的接口37上执行此操作, 然后保存配置。
Ftos >启用
Ftos #配置
Ftos (config) #接口 fortyGigE 0/37
Ftos (配置-0/37)intf cr4 autoneg
Ftos (配置-0/37) #尾页
Ftos #写入内存
注意:此命令仅适用于四十兆位以太网接口。
要删除上述配置, 请在接口配置中运行以下命令。
Ftos (0/37) #无intf 类型 cr4 autoneg
Affected Products
PowerSwitch S4810P, PowerSwitch S5000, Force10 S60-44T, PowerSwitch S6000, Force10 Z9000, Dell Networking Z9500Article Properties
Article Number: 000127228
Article Type: Solution
Last Modified: 05 Jun 2025
Version: 5
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.