PowerFlex: How to reset oscillating_failure_counters from the Primary MDM

Summary: This Article explains how to reset the oscillating_failure_counters from the primary MDM Oscillating_failure_counters are used to trace the all-time number of networks flapping between nodes, and to understand if this is an ongoing problem or a historical problem, counters must be reset. ...

This article applies to This article does not apply to This article is not tied to any specific product. Not all product versions are identified in this article.
Check out other resources

Instructions

Oscillating_failure_counters are used to trace the all-time number of networks flapping between nodes, and to understand if this is an ongoing problem or a historical problem; counters must be reset. 

Resetting oscillating_failure_counters on the Primary MDM

  1. Log in to the Primary MDM with SSH
  2. Log in to the cluster with  
    scli --login --username admin
  3. Perform the following command  
    scli --reset_oscillating_failure_counters --all_counters --all_sdc
  4. Will prompt you to enter 'Y" to approve this certificate and add it to the truststore.
  5. When finished, update inventory on Gateway

Additional Information

Related Article: PowerFlex: Oscillating Failure Counter Parameter SIO01.03.0000001 and SIO01.03.0000002

Affected Products

ScaleIO
Article Properties
Article Number: 000323513
Article Type: How To
Last Modified: 27 Jan 2026
Version:  2
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.