Connectrix: Cisco: show running-config diff는 업그레이드 후 차이를 표시합니다.
Summary: NX-API가 활성화된 상태에서 스위치를 버전 8.4(2a)에서 9.4(2a)로 업그레이드한 후 시작 구성에 다음 추가 줄이 관찰되었습니다. "NXAPI 신뢰 지점?". 이 줄은 실행 중인 구성에 없습니다.
This article applies to
This article does not apply to
This article is not tied to any specific product.
Not all product versions are identified in this article.
Symptoms
실행 "copy running-config startup-config" 복사 작업을 시도한 후에도 불일치가 지속되므로 명령을 사용해도 문제가 해결되지 않습니다.
이는 Cisco 버그 ID CSCwo14155의 일부입니다.
`show running-config` feature nxapi nxapi http port 8080 `show startup-config` feature nxapi nxapi http port 8080
9.4(2a)로 업그레이드 후
`show running-config` feature nxapi nxapi http port 8080 nxapi ssl protocols TLSv1.1 TLSv1.2 `show startup-config` feature nxapi nxapi http port 8080 nxapi ssl protocols TLSv1.1 TLSv1.2 nxapi trustpoint ? <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<< switch# show run diff *** Startup-config --- Running-config *************** *** 3411,3421 **** - nxapi trustpoint <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<< (-) --- 3411,3420 ---- switch# copy r s [########################################] 100% Copy complete. switch# switch# sh running-config diff *** Startup-config --- Running-config *************** *** 3384,3394 **** - nxapi trustpoint <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<< (-) --- 3384,3393 ---- - No Trustpoint configured on switch switch# sh crypto ca trustpoint
Cause
이것은 8.4(2a)에서 9.4(2a)로 업그레이드하는 동안 MDS-9706에서만 나타나는 외관 버그입니다.
Resolution
해결 방법:
NXAPI 기능을 비활성화했다가 활성화하면 문제가 해결됩니다. 다음은 구문입니다.
#no feature nxapi #copy r s #sh run diff #feature nxapi # nxapi http port 8080 #nxapi ssl protocols TLSv1.1 TLSv1.2 #copy r s #sh run diff
참고: 이는 운영 중단 없는 명령입니다.
Cisco 개발 팀에서 영구 수정을 기다리고 있습니다.
Affected Products
Connectrix MDS-9706, Connectrix MDS-9706-V2Article Properties
Article Number: 000289851
Article Type: Solution
Last Modified: 27 Feb 2025
Version: 1
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.