Connectrix: Syslog-Weiterleitung aktiviert, sendet aber nicht an Splunk-Server

Summary: Die auditCfg-Einstellungen (--class, --enabled --show) sind aktiviert, senden jedoch keine Syslog-Informationen an den Splunk-Server.

This article applies to This article does not apply to This article is not tied to any specific product. Not all product versions are identified in this article.
Check out other resources

Symptoms

Die Syslog-Weiterleitung auf dem Brocade-Switch wurde aktiviert, um sie an den Splunk-Server zu senden, die Syslog-Informationen werden jedoch nicht gesendet.

 

Cause

** SOMEONE SET THE RASLOG QUIET TIME FOR AUDITCFG BACK IN OCT **

Thu Oct 25 06:43:54 2018         admin, , xxx.xx.xx.x, rasadmin --quiet -enable 3
Thu Oct 25 06:44:02 2018         admin, , xxx.xx.xx.x, rasadmin --quiet -show

** HERE IS THE CONFIG FILE FROM non-working **

auditlog.quiettime.dow:FOREVER
auditlog.quiettime.enable:1
auditlog.quiettime.endtime:NA
auditlog.quiettime.starttime:NA
snmp.auditInterval:60
audit.cfg.class:2,4,10
audit.cfg.severity:4

audit.cfg.state:1

*** HERE IS THE CONFIGSHOW FROM working ***

auditlog.quiettime.dow:NA
auditlog.quiettime.enable:0
auditlog.quiettime.endtime:NA
auditlog.quiettime.starttime:NA
snmp.auditInterval:60
audit.cfg.class:2,10
audit.cfg.severity:3
audit.cfg.state:1

 

Resolution

Der Kunde kann den folgenden Befehl verwenden, um die Syslog-Weiterleitung an Splunk zuzulassen.

rasadmin --quiet -disable 3

 

Affected Products

Connectrix DS-6610B

Products

Connectrix DS-6610B
Article Properties
Article Number: 000057296
Article Type: Solution
Last Modified: 21 Oct 2025
Version:  4
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.