MX7000: Unable to configure SNMPv3 using the OpenManage Enterprise Modular Graphical UI
Summary: The OpenManage Enterprise Modular Graphical User Interface (UI) does not provide any option to configure SNMPv3 parameters for MXG610s Fiber Channel Switch Module.
This article applies to
This article does not apply to
This article is not tied to any specific product.
Not all product versions are identified in this article.
Symptoms
The OpenManage Enterprise Modular UI only provides options to set SNMPv1 and SNMPv2 parameters for the MXG610s Fiber Channel Switch Module. It does not provide an option to set SNMPv3 parameters for this module.
The MXG610s Fiber Channel Switch Module runs on Fabric OS. Fabric OS version 9.1.1 and above have disabled SNMPv1 and SNMPv2 for higher security.
Hence, users cannot configure Simple Network Management Protocol (SNMP) on their Fiber Channel Switches using the OpenManage Enterprise Modular UI.
The MXG610s Fiber Channel Switch Module runs on Fabric OS. Fabric OS version 9.1.1 and above have disabled SNMPv1 and SNMPv2 for higher security.
Hence, users cannot configure Simple Network Management Protocol (SNMP) on their Fiber Channel Switches using the OpenManage Enterprise Modular UI.
Cause
MXG610s Fiber Channel Switch Module runs on Fabric OS version 9.1.1
Resolution
Users can configure SNMPv3 on their Fiber channel switches using the Command line interface (CLI). Refer to the Brocade Fabric OS Command Reference Manual
for details on how to configure SNMPv3.
for details on how to configure SNMPv3.
Affected Products
Dell EMC Networking MXG610s, Dell EMC Networking MX-G610sArticle Properties
Article Number: 000226734
Article Type: Solution
Last Modified: 12 Jul 2024
Version: 1
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.