Connectrix：已啟用系統記錄轉送，但未傳送至 Splunk 伺服器

Summary: auditCfg （--class， --enabled --show） 設定已啟用，但不會將系統記錄資訊傳送至 Splunk 伺服器。

This article applies to This article does not apply to This article is not tied to any specific product. Not all product versions are identified in this article.
Check out other resources

Symptoms

啟用將 Brocade 交換器上的系統記錄轉送至 Splunk 伺服器，但未傳送系統記錄資訊。

 

Cause

** SOMEONE SET THE RASLOG QUIET TIME FOR AUDITCFG BACK IN OCT **

Thu Oct 25 06:43:54 2018         admin, , xxx.xx.xx.x, rasadmin --quiet -enable 3
Thu Oct 25 06:44:02 2018         admin, , xxx.xx.xx.x, rasadmin --quiet -show

** HERE IS THE CONFIG FILE FROM non-working **

auditlog.quiettime.dow:FOREVER
auditlog.quiettime.enable:1
auditlog.quiettime.endtime:NA
auditlog.quiettime.starttime:NA
snmp.auditInterval:60
audit.cfg.class:2,4,10
audit.cfg.severity:4

audit.cfg.state:1

*** HERE IS THE CONFIGSHOW FROM working ***

auditlog.quiettime.dow:NA
auditlog.quiettime.enable:0
auditlog.quiettime.endtime:NA
auditlog.quiettime.starttime:NA
snmp.auditInterval:60
audit.cfg.class:2,10
audit.cfg.severity:3
audit.cfg.state:1

 

Resolution

客戶可以使用下列命令允許將系統記錄轉送至 splunk。

rasadmin --quiet -disable 3

 

Affected Products

Connectrix DS-6610B

Products

Connectrix DS-6610B
Article Properties
Article Number: 000057296
Article Type: Solution
Last Modified: 21 Oct 2025
Version:  4
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.