Dell EMC Networking OS6 How to stack N1500 series switches

摘要: Information about stacking Dell EMC Networking N1500 series switches.

本文章適用於 本文章不適用於 本文無關於任何特定產品。 本文未識別所有產品版本。
查看其他資源

說明

 
To stack N1500 switches together, do the following.
 
1.  Update each switch to the latest firmware using the instruction included in the zip file. The firmware may be found on dell.com/support
2.  Configure ports to be used for stacking. It is recommended to use at least two ports on each switch to allow a ring topology connection.
3.  Input these commands to set a port to stack mode, this example uses two 10-GigabitEthernet ports for stacking.

console>enable

console#config

console(config)#stack

console(config-stack)#stack-port tengigabitethernet 1/0/1 stack

console(config-stack)#stack-port tengigabitethernet 1/0/2 stack

console(config-stack)#end

console#copy running-configuration startup-configuration

console#reload

 

NOTE: You must reboot the switch for ports to transition into stacking mode.

 

NOTE: You may stack only on the 10-Gigabit

 

1.  Power off the switches. Connect the stacking ports in a ring topology.
2.  Power on the desired primary switch first and wait until you can access it. Afterwards power on the next switch one at a time until every switch is powered on. They will add themselves to the stack.

 

NOTE: The Primary and Operation Standby switches keep the startup-configuration of the stack. You can only access the console port from the Primary.

NOTE: The N1500 series switches support up to 4 units in a stack.

 

受影響的產品

PowerSwitch N1500 Series
文章屬性
文章編號: 000121347
文章類型: How To
上次修改時間: 18 4月 2026
版本:  7
向其他 Dell 使用者尋求您問題的答案
支援服務
檢查您的裝置是否在支援服務的涵蓋範圍內。