How to create Link Aggregation Groups (LAGs) on Dell Networking EMC OS9 Switches

摘要: How to set up LAG on Dell Force10 switch, How to set up port channel on Dell switch, How to configure link aggregation on Dell Force10 switch

本文章適用於 本文章不適用於 本文無關於任何特定產品。 本文未識別所有產品版本。
查看其他資源

說明


This article explains how Link Aggregation Groups (LAGs) are implemented on Dell Networking Force10 Switches.

 

Options for LAG type

 

  • Static
  • Link Aggregation Control Protocol (LACP)


Example of Static LAG


 

Command

Purpose

ftos#configure

Enter configuration mode.

ftos(conf)#interface port-channel 1

Define the port-channel number.

ftos(conf-if-po-1)#channel member te 0/1 - 4

Set the range of physical ports needed in the port channel.  Command requires a space between the numbers and hyphen.

ftos(conf-if-po-1)#no shutdown

Set Admin mode to up on the port channel.


 

Example of LACP LAG



LACP Modes

 

  • Active -- In this state, the interface is said to be in the "active negotiating state." LACP runs on any link that is configured to be in this state. A port in Active state automatically initiates negotiations with other ports by initiating LACP packets.
  • Passive -- Passive — In this state, the interface is not in an active negotiating state, but LACP runs on the link. A port in Passive state responds to negotiation requests from ports in Active state. Ports in Passive state respond to LACP packets.

     

Command

Purpose

ftos# configure

Enter configuration mode.

ftos(conf)# interface range te 0/1 - 4

Enter the range of physical ports needed for the port channel.  Command requires a space between the numbers and hyphen.

ftos(conf-inf-range-gi0/0-3)# no shutdown

Set Admin mode to up on the port.

ftos(conf-inf-range-gi0/0-3)# port-channel-protocol lacp

Enter port channel protocol type LACP.

ftos(conf-inf-range-gi0/0-3-lacp)#port-channel 1 mode [active | passive]

Define the port-channel number and mode.


 

Verification & Monitoring commands


 

Command

Purpose

ftos#show interfaces port-channel brief

Shows abbreviated details of all port channels configured.

ftos#show lacp 1

Shows details of specific port channel in LACP mode.

ftos#show interfaces port-channel 1

Shows details of specified port channel interface.



 

Configuration options provided are validated using firmware version 9.4.0.0. Depending on the firmware version installed you may see slight differences in the command options.

 

受影響的產品

Force10 MXL Blade, Force10 S25-01-GE-24P, Force10 S25-01-GE-24T, Force10 S25-01-GE-24V, Force10 S50-01-GE-48T-V, Force10 S50-01-GE-48T, PowerSwitch S4810P, Force10 S50P, Force10 S55T, Force10 S60-44T
文章屬性
文章編號: 000121874
文章類型: How To
上次修改時間: 18 4月 2026
版本:  6
向其他 Dell 使用者尋求您問題的答案
支援服務
檢查您的裝置是否在支援服務的涵蓋範圍內。