Dell Unity™ Family Unisphere® Command Line Interface User Guide

PDF

Change disk settings (virtual deployments only)

Change settings of an existing disk.

Format

/env/disk -id <value> set [-async] [-name <value>] [-tier <value>]

Object qualifier

QualifierDescription
-idDisk identifier.

Action qualifier

QualifierDescription
-asyncRun the operation in asynchronous mode.
-nameSpecify the new name for the disk.
-tierSpecify the new tier. Valid values are:
  • capacity
  • performance
  • extreme
NOTE:Disks without a tier cannot be used for pool provisioning.

Example

The following command changes the name of the virtual disk with the ID "vdisk_1".

uemcli -d 10.0.0.2 -u Local/joe -p MyPassword456! /env/disk -id vdisk_1 set -name "High-performance storage" 
Storage system address: 10.0.0.2
Storage system port: 443
HTTPS connection

Operation completed successfully.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\