- Notes, cautions, and warnings
- Introduction
- Package contents
- Hardware requirements
- Identifying Parts and Features
- Important Information
- Quick Setup of Hardware
- Thunderbolt Settings and Security Options
- Setup of External Monitors
- Removing the USB Type-C cable module
- Technical specifications
- Dell docking station firmware update
- Frequently asked questions
- Troubleshooting the Dell Thunderbolt Docking Station WD19TB
- Getting help
Dell Docking Station WD19 Thunderbolt User Guide
Display Resolution Table
|
Display Port Available Bandwidth |
Single Display (maximum resolution) |
Dual Display (maximum resolution) |
Triple Display (maximum resolution) |
Quad Display (maximum resolution) |
|---|---|---|---|---|
| HBR2 (HBR2 x2 lanes - 8.6 Gbps) |
DP1.4/HDMI2.0/MFDP Type-C: 4K (3840 x 2160) @30 Hz |
|
|
NA |
| HBR3 (HBR3 x2 lanes - 12.9 Gbps) |
DP1.4/HDMI2.0/MFDP Type-C: 4K (3840 x 2160) @60 Hz |
|
|
NA |
|
Display Port Available Bandwidth |
Single Display (maximum resolution) |
Dual Display (maximum resolution) |
Triple Display (maximum resolution) |
Quad Display (maximum resolution) |
|---|---|---|---|---|
| HBR2 (HBR2 x8 lanes - 34.5 Gbps) |
DP1.4/HDMI2.0/MFDP Type-C/USB Type-C TB: 4K (3840 x 2160) @60 Hz |
|
|
NA |
|
HBR3 (HBR3 x4 lanes + HBR3 x1 - 32.4 Gbps) For Precision 7530/7540/7730/7740 with discrete graphics card |
DP1.4/HDMI2.0/MFDP Type-C/USB Type-C TB: 8K (7689x4320) @30 Hz |
|
|
|
NOTE HDMI2.0 and MFDP (Multi-Function DisplayPort) Type-C ports on the back of all docks in the WD19 family are toggled. HDMI2.0 and MFDP Type-C cannot support dual monitors simultaneously. Only one of these ports can be used as a display device at a time.
NOTE If higher resolution monitors are used, the Graphics driver makes a judgment based on monitor specifications and display configurations. Some resolutions may not be supported and so will be removed from the Windows Display Control Panel.
NOTE Linux operating system is unable to physically turn-off built-in display, the external display numbers will be one less than the display numbers listed in above tables.
If the Display Port Data Rate is HBR2, then, the maximum resolution that Linux supports is 8192 x 8192 (counted with built-in display plus external display).
WD19TB for Thunderbolt systems with HBR2:
- If the built-in display resolution is FHD (1920 x 1080 @60 Hz), two external displays with QHD (2560 x 1440) @60 Hz could be supported.
- If the built-in display resolution is 4K (3840 x 2160 @60 Hz), only one external display with QHD (2560 x 1440) @60 Hz could be supported.
NOTE Resolution support is also dependent on the monitor’s Extended Display Identification Data (EDID) resolution.
NOTE The 5K resolution support is only available in either of these conditions:
- With discrete graphics mode only, or special graphics mode, or
- Using the Thunderbolt 3 Type–C to a dual DisplayPort adapter.
NOTE Configuration that is supported with AMD and Nvidia in discrete-only mode or special-graphics mode. These modes are listed in the BIOS for the Dell Precision mobile workstations 7000 series and will require disabling switchable graphics for discrete-only mode or enabling special-graphics mode when Switchable is enabled. If the system does not have these options in the BIOS, then four monitors are NOT supported.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\