Dell PowerEdge RAID Controller 9 User’s Guide H330, H730, and H830

Replacing the tethered battery of a PERC 9 mini blade card

1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
   NOTE: It is recommended that you always use a static mat and static strap while working on components in the interior of the system.
2. Open the system.
3. Locate the battery carrier of the PERC card on the system board.
4. Push the tab on the battery carrier forward until the battery carrier disengages from the slot of the chassis.

   

   1. tab on the battery carrier
   2. battery carrier of the tethered battery

5. Disconnect the battery cable connector from the connector on the mini blade and lift the battery carrier away from the system.
6. Pull the battery out of the battery carrier.

   

   1. battery carrier
   2. slot on the tethered battery carrier
   3. tethered battery cable
   4. battery
   5. guide for the battery on the battery carrier

7. Align the lower end of the replacement battery into the battery carrier and push the battery towards the carrier until it clicks into place.

   

   1. battery carrier
   2. slot for the tethered battery carrier
   3. tethered battery cable
   4. battery
   5. guide for the battery on the battery carrier

8. Align the battery carrier with the guide pin slots on the chassis and lower the battery carrier until the guide pin slots on the battery carrier engage with the guide pins on the chassis

   

   1. battery carrier
   2. tab on the battery carrier
   3. guide slot on the chassis
   4. guide pins on the chassis

9. Connect the battery cable to PERC 9 mini blade controller.
10. Close the system.
11. Reconnect the system to its electrical outlet and turn on the system, including any attached peripherals.