Monitor mount for 2016 E-series and E2417H Dell monitors Installation guide

Use the following instructions to attach the client to the E-series mount:

1. Preparing the client—Use a Phillips-head screwdriver to remove the filler screws from the side of the client and replace them with the shoulder screws.
2. Removing the cover plates and screws from the monitor.
   • Place the monitor panel face down on a soft cloth or cushion.
   • Remove cover plate if present.
   • Remove the monitor screws from the back of the monitor, and use them when you proceed with installation later.
   • NOTE: During installation, position the monitor with the base of the stand hanging over the edge of the table.
   
3. Attaching the base extender—Slide the base extender onto the monitor stand and use the screws provided in the tool kit to secure the base extender to the monitor stand.
   • CAUTION: Do not overtighten the screws.
4. Attaching E-series mount to the monitor —

   Position the E mount on the back of the monitor and attach it by using the monitor screws at 4 locations.

   
   • CAUTION: Do not overtighten the screws.
5. Attaching the client—Slightly tip the client to align and insert the four protruding shoulder screws into the cutout areas of the E-series mount. Slide the client until it snaps into place. The security latch moves automatically when the shoulder screws are inserted. The security latch is marked with the number 1 in the following image.
   • CAUTION: The power button should face towards the security latch and air vents should face outwards for proper heat dissipation.

   

   1. Security latch

6. Connecting cables—To complete your setup, make all the desired connections, and then plug the AC power cord into an AC wall outlet.