- Notes, cautions, and warnings
- Before working inside your computer
- After working inside your computer
- Removing the base cover
- Replacing the base cover
- Removing the battery
- Replacing the battery
- Removing the coin-cell battery
- Replacing the coin-cell battery
- Removing the hard drive
- Replacing the hard drive
- Removing the wireless card
- Replacing the wireless card
- Removing the display assembly
- Replacing the display assembly
- Removing the I/O board
- Replacing the I/O board
- Removing the speakers
- Replacing the speakers
- Removing the status-light board
- Replacing the status-light board
- Removing the solid-state drive
- Replacing the solid-state drive
- Removing the touchpad
- Replacing the touchpad
- Removing the system board
- Replacing the system board
- Removing the power-adapter port
- Replacing the power-adapter port
- Removing the palm-rest and keyboard assembly
- Replacing the palm-rest and keyboard assembly
- Downloading drivers
- System setup
- Troubleshooting
- Getting help and contacting Dell
Inspiron 14 7000 Service Manual
Procedure
NOTE The rubber grommets
may get pushed out while replacing the speaker. Ensure that the rubber
grommets are in their position after placing the speaker on the palm
rest and keyboard assembly.
- Using the alignment posts, align and place the speakers on the palm rest and keyboard assembly.
- Route the speaker cable through the routing guides on the palm rest and keyboard assembly.
- Connect the speaker cable to the system board.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\