You can use the following options and parameters to configure application nodes in ApplicationLaunchConfig.xml:
Table 1. Options to configure nodesOptions to configure nodes
Option
Description
Add -Application
Option to add an application node.
Remove -Application
Option to delete an application node.
Table 2. Parameters to configure nodesParameters to configure nodes
Parameter
Values
Name:<name of the application>
[Application name]
Path:<path of the application>
[Application path]
Arguments:< specify the configuration information when the application is launched>
[Argument]
Event:<event to execute the command>
USER_LOGOFF
SVC_STARTUP
ON_SHUTDOWN
USER_LOGIN
Examples to configure nodes using xDCM
Table 3. Examples to configure nodes using xDCMExamples to configure nodes using xDCM
Scenario
Command
Adding an application node that is used by ClientServiceEngine service to run the TestApp.exe file with an argument -t when you log off from the system.
Deleting an application node from ExampleApp application.
ALM.exe -Remove -Application -Name: ExampleApp
NOTE:
You must provide unique names to add a new application entry to the ApplicationLaunchConfig.xml using ALM.exe.
Only three execution event values USER_LOGOFF, SVC_STARTUP, and ON_SHUTDOWN, are supported in the ALM application. You can add only one of these values to each event.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\