Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In

Dell PowerEdge FX2 and FX2s Enclosure Owner's Manual

PDF

Removing the cooling-fan cage

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
NOTE: This is a field replaceable unit (FRU). Removal and installation procedures must be performed only by Dell certified service technicians.
NOTE: You must remove the cooling-fan cage to service other components inside the system.
  1. Ensure that you read the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the system cover.
  4. Remove the cooing fans.

Steps

  1. Loosen the six screws that secure the cooling-fan cage to the system.
  2. Lift the cooling-fan cage out of the system.
    Figure 1. Removing and installing the cooling-fan cage
    This figure shows removing and installing the cooling-fan cage.
    1. screw (6)
    2. cooling-fan cage
    Figure 2. Cooling-fan cage top view
    This figure shows the location of six captive screws.
    1. screw location (6)

Next steps

Install the cooling-fan cage.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\