Dell Networking Open Automation Guide 9.10(0.1) May 2016

dhcp-timeout

Allows you to configure the DHCP timeout limit.

dhcp-timeout minutes

To reset the DHCP time out limit, use the no dhcp-timeout minutes command.

dhcp-timeout minutes

Configure the DHCP timeout (in minutes) after which the BMP exits. The range is from 0 to 50. If you enter a range of 0, the timeout is 0 (no limit).

Defaults

Disabled

Command Modes

RELOAD-TYPE CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.10(0.0)	Introduces on the S6100–ON.
9.9(0.0)	Introduced on the C9010.
9.8(2.0)	Introduced on the S3100 series.
9.8(1.0P1)	Introduced on the Z9100–ON.
9.8(0.0P5)	Introduced on the S4048–ON.
9.8(0.0P2)	Introduced on the S3048–ON.
9.7(0.0)	Introduced on the S4810, S4820T, S5000, S6000, S6000–ON, Z9000, Z9500, IOA, and MXL.

Related Commands

reload-type — allows you to configure the reload-type options in reload-type sub command mode.
show reload-type — displays the current Reload mode (BMP mode or Normal mode).