Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge R720 and R720xd Owner's Manual

PDF

Removing The I/O Panel (PowerEdge R720xd)

  • CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
  1. If installed, remove the front bezel.
  2. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
  3. Open the system.
    • CAUTION: To prevent damage to the I/O cable, you must release the locking tab before removing or installing the I/O cable from the connector on the hard-drive backplane.
  4. Rotate the locking tab on the I/O cable connector clockwise 90 degrees to release the lock.
  5. Disconnect the I/O cable from the backplane.
  6. Remove the three Torx screws securing the I/O panel to the chassis.
  7. Pull out the I/O panel cable through the channel on the chassis.
    Figure 1. Removing and Installing the I/O Panel —PowerEdge R720xd The figure shows removing and installing the I/O panel—PowerEdge R720xd.
    1. I/O panel cable
    2. hard-drive backplane
    3. Torx screws (3)
    4. I/O panel
    5. chassis

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\