Monitor mount for 2016 E-series and E2417H Dell monitors Installation guide

Use the following instructions for mounting the Wyse 3010, Wyse 3020, Wyse 3030, Wyse 3030LT, and Wyse 5030 clients to the E-series monitor mount. These thin clients require mounting of the thin client to their respective horizontal stands before installing the thin client to the E-series monitor mount. The following horizontal stands are required by the respective thin client models:

1. Preparing the client
   1. If the thin client is installed on the horizontal stand, remove it from the stand. On the inside of the horizontal stand, slide one of the four hex nuts that comes with the tool kit into one of the four screw holes.
   2. From outside of the horizontal stand, insert a shoulder screw into the hex nut and tighten it.
   3. Repeat for remaining three hex nuts and shoulder screws.
   4. Insert the client into the horizontal stand, with the power button facing upward, and the extended plastic ledge on the opposite side.
   
   • NOTE:
     1. Slide the hex nut across the stand surface so that it easily slips into the recessed cut-out in the horizontal stand.
     2. Use the horizontal stand with the hex holes.
2. Attaching the base extender –Slide the base extender onto the monitor stand and use the screws provided in the tool kit to secure the base extender to the monitor stand.
3. Attaching the E mount to the monitor –Remove the four screws from the back of the monitor. Position the E mount on the back of the monitor, and attach it using the same screws.
4. Attaching the client –Align the client, and insert the shoulder screws into the four cut-out areas of the mount. The security latch moves automatically when the shoulder screws are inserted. The security latch is highlighted with the number 1 in the following image.

   1. Security latch.

5. Connecting cables –To complete your setup, make all the desired connections, and then plug the AC power cord into an AC wall outlet.