Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell PowerEdge R730xd Owner's Manual

Installing the I/O panel

Prerequisites

  1. Follow the safety guidelines listed in safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. Keep the T15 Torx screwdriver ready.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

Steps

  1. Fold the PPID label around the cable.
  2. Push the cable until the cable passes completely through the channel.
    CAUTION: To prevent damage to the I/O cable, you must release the locking tab before removing or installing the I/O cable from the connector on the hard drive backplane.
  3. If locked, rotate the locking tab on the I/O cable connector clockwise 90 degrees to release the lock.
  4. Connect the I/O panel cable to the connector on the hard drive backplane.
  5. Rotate the locking tab on the I/O cable connector counter clockwise 90 degrees to secure the lock.
  6. Tighten the screws to secure the control panel to the chassis.
    NOTE: You must route the cable properly to prevent it from being pinched or crimped.
    Figure 1. Installing the I/O panel
    This figure shows installing the I/O panel.
    1. I/O panel cable
    2. hard drive backplane
    3. screw (3)
    4. I/O panel
    5. chassis

Next steps

Follow the procedure listed in the After working inside your system section.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\