Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Partner Program Sign In
Contact Us

Dell PowerEdge R730 Owner's Manual

PDF

Removing the cable retention bracket

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. If installed, remove the cooling shroud.
  4. Remove the PCIe card holder.
  5. Remove all cables routed through the cable retention bracket.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

Steps

  1. Pull the tab to release it from the notch and slide the cable retention bracket toward the front of the chassis to release it from the chassis.
  2. Lift the cable retention bracket out of the chassis.
    Figure 1. Removing the cable retention bracket
    This figure shows removing the cable retention bracket.
    1. alignment pin (2)
    2. tab
    3. cable retention bracket

Next steps

  1. Install the cable retention bracket and reconnect all cables routed through the cable retention bracket.
  2. If removed, install the PCIe card holder.
  3. If removed, install the cooling shroud.
  4. Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\