- Notes, cautions, and warnings
- PowerFlex custom node deployment overview
- Revision history
- Product requirements
- Configuring the hardware
- Installing the Linux operating system
- Network architecture and physical connectivity for Linux servers
- Configuring network ports on Linux servers
- Linux ports overview
- Configure network ports on PowerFlex custom node servers
- PowerFlex custom node R650, R750, or R6525 NIC and iDRAC port locations
- PowerFlex custom node R650 port designations - Linux (1*OCP + PCIe slot)
- PowerFlex custom node R6525 port designations - Linux (1*OCP + PCIe slot)
- PowerFlex custom node R750 port designations - Linux (2 PCIe slots)
- Correlate the PCIe slot locations and interface names on PowerFlex custom node servers
- Configure the ports on RHEL/CentOS nodes
- Configure the ports on SLES nodes
- Installing the Drivers
- Preparing Disks
- Additional configurations
- Reference material
- Getting help
Dell PowerFlex Custom Node R650-R6525-R750 Hardware Configuration and Operating System Installation Guide for Linux
Installing the Linux operating system
This section describes the procedures for installing a Linux operating system on a PowerFlex custom node.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\