Dell EMC Networking Command-Line Reference Guide for the C9010 Series Version 9.14.2.1

PDF

About this Guide

This CLI guide provides information about the Dell Networking operating system (OS) command-line interface (CLI) supported on a C9010 console to configure a C9010 switch, C1048P, N20xx, and N30xx port extenders. The C9010 switch is also referred to as network director or control bridge. The port extenders are also referred to as rapid access nodes.

This book also includes information about the protocols and features supported in the Dell Networking OS on the C9000 switch.

References

For more information about your system, go to the Dell Networking Support page and refer to the following documents:

  • Dell Networking C9000 Getting Started Guide
  • Dell Networking C9000 Installation Guide
  • Dell Networking C9000 Configuration Guide
  • Dell Networking C9000 Release Notes

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\