- Notes, Cautions, and Warnings
- Working on Your Computer
- Removing and
Installing Components
- Recommended Tools
- Removing the Cover
- Installing the Cover
- Removing the Front Bezel
- Installing the Front Bezel
- Removing the Drive Cage
- Installing the Drive Cage
- Removing the Wireless Local Area Network (WLAN) Card
- Installing the WLAN Card
- Removing the Optical Drive
- Installing the Optical Drive
- Removing the Hard Drive
- Installing the Hard Drive
- Removing the Intrusion Switch
- Installing the Intrusion Switch
- Memory Module Guidelines
- Removing the Memory
- Installing the Memory
- Removing the Coin-Cell Battery
- Installing the Coin-Cell Battery
- Removing the System Fan
- Installing the System Fan
- Removing the Speaker
- Installing the Internal Speaker
- Removing the Power Switch
- Installing the Power Switch
- Removing the Input/Output(I/O) Panel
- Installing the Input/Output(I/O) Panel
- Removing the Power Supply Unit
- Installing the Power Supply Unit
- Removing the Heat Sink
- Installing the Heat Sink
- Removing the Processor
- Installing the Processor
- Removing the System Board
- System Board Layout
- Installing the System Board
- System Setup
- Diagnostics
- Troubleshooting Your Computer
- Specifications
- Contacting Dell
Dell OptiPlex 9010/7010 Ultra Small Form Factor Owner's Manual
Installing the Drive Cage
- Place the drive cage on the edge of the computer near the front bezel to allow access to the cable connectors on the hard drive.
- Connect the data cable and power cable to the back of the hard drive.
- Flip over the drive cage and insert it into the chassis.
- Connect the data cable and power cable to the back of the optical drive.
- Install the front bezel.
- Install the cover.
- Follow the procedures in After Working Inside Your Computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\