- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw List
- Major components of your system
- MicroSD-card
- SIM card tray
- Base cover
- Battery cable
- Memory module
- M.2 solid state drive
- M.2 solid-state drive conversion bracket
- M.2 solid-state drive conversion plate
- Hard-disk drive assembly
- WLAN card
- Wireless Wide Area Network (WWAN) card
- System fan
- Battery
- I/O cable
- Display assembly
- Heat sink
- Removing the heatsink assembly - for computers with discrete graphics card
- Installing the heatsink assembly - for computers with discrete graphics card
- Removing the heatsink assembly - for computers with integrated graphics card
- Installing the heatsink assembly - for computers with integrated graphics card
- Power adapter port
- Coin-cell battery
- USB cable
- Ethernet port
- I/O board
- Power button
- System board
- Speakers
- Touchpad
- WWAN I/O board
- Palmrest assembly
- Display bezel
- Display panel
- Camera
- Display cable
- Display back-cover
- Drivers and downloads
- BIOS Setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell Technologies
Latitude 3520 Service Manual
Installing the display panel
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE:The display panel is pre-assembled with the display brackets as a single service part. Do not pull and release the Stretch Release (SR) Tapes from the display panel and separate the brackets from the display panel.
The following images indicate the location of the display panel and provide a visual representation of the installation procedure.
Steps
- Align and place the display panel on the display assembly.
- Connect the display cable to the connector on the display panel, close the latch and affix the adhesive tape.
- Install the six (M2.5x3) and two (M2.5x3) screws to secure the left and right hinge brackets in place.
- Gently flip over the display panel.
Next steps
- Install the display bezel.
- Install the display assembly.
- Install the I/O board cable.
- Install the WWAN card for 4G LTE enabled systems..
- Install the WLAN card.
- Install the base cover.
- Install the SIM card tray for 4G LTE enabled systems.
- Install the microSD-card.
- Exit the service mode
- Follow the procedure in after working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\