Removing the
custom GPU brackets from the GPUs removed from your system
The Nvidia, Intel, or AMD brackets are installed
on the Nvidia, Intel, or AMD GPUs shipped with your system. These
brackets should be removed from the Nvidia, Intel, or AMD GPUs removed
from your system and installed on the replacement GPUs.
Prerequisites
CAUTION: Many repairs may only
be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation,
or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that are
shipped with your product.
NOTE: This
is a Field Replaceable Unit (FRU). Removal and installation procedures
should be performed only by Dell certified service technicians.
Follow the safety guidelines listed in the Safety
instructions section.
Keep the Philips #1 and #2 screwdrivers ready.
Remove the GPU riser cable board.
NOTE: Depending
on the type of Nvidia GPUs supported on your system, the location
of the screws and type of GPU brackets will vary.
Steps
Remove the screws securing the front I/O bracket
to the GPU, and remove the I/O bracket.
Remove the screws securing the support bracket
to the GPU, and remove the support bracket.
Removing the
custom Nvidia GPU I/O brackets and the support brackets:
Removing the
custom Intel GPU I/O brackets and the support brackets :
Removing the
custom AMD I/O brackets and the support brackets:
Next steps
Remove the
GPU brackets from the replacement GPUs.
NOTE: This procedure is not
applicable to the AMD GPUs since the replacement AMD GPUs are shipped
without brackets.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\