Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge R330 Owner's Manual

PDF

Removing the LED control panel assembly

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

  1. Follow the safety guidelines listed in Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. Disconnect the cables connected to the control panel module.

CAUTION: Do not use excessive force when removing the control panel as it can damage the connectors.

Steps

  1. For cabled hard drive chassis, perform the following steps:
    1. Remove the screw(s) that secure the LED panel to the chassis.
    2. Remove the LED panel.
  2. Remove the screws that secure the control panel board to the chassis.
  3. Lift the control panel board away from the chassis.
    Figure 1. Removing the LED module—four cabled hard drive chassis
    This figure shows removing the LED module.
    1. LED module
    2. screw (2)
    3. slot on the chassis
    Figure 2. Removing the LED control panel board—four cabled hard drive chassis
    This figure shows removing the control panel board.
    1. screw (2)
    2. control panel connector cable
    3. control panel board
    4. USB connector cable
    5. standoff on the chassis (2)

Next steps

  1. Install the LED control panel assembly.
  2. Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\