You can configure events and alarms by using
the Initial Configuration Wizard or from the Settings tab for events and alarms. To receive events
from the servers, OMIVV is configured as trap destination. For 12th
generation hosts and later, ensure that the SNMP trap destination
is set in iDRAC. For hosts earlier than 12th generation, ensure that the
trap destination is set in OMSA.
About this task
NOTE OMIVV supports SNMP
v1 and v2 alerts for 12th generation hosts and later and supports
only SNMP v1 alerts for hosts earlier than 12th generation.
Steps
In the Initial Configuration Wizard, under Event Posting Levels, select one of
the following:
Do not post any events—block hardware events
Post all events—post all hardware events
Post only Critical and Warning events—post only critical or warning level hardware events
Post only Virtualization-Related Critical and Warning Events—post only virtualization-related critical and warning event, which is the default event posting level
To enable all hardware alarms and events,
select Enable Alarms for Dell Hosts.
NOTE The Dell hosts that have alarms enabled respond to some specific
critical events by entering in to maintenance mode and you can modify
the alarm, when required.
The Enabling Dell Alarm Warning dialog box is displayed.
To accept the change, click Continue, or to cancel the change, click Cancel.
NOTE Ensure that you complete this step only if you select Enable Alarms For Dell Hosts.
To restore the default vCenter alarm settings
for all managed Dell servers, click Restore Default Alarms.
It might take up to a minute before the change takes
effect.
NOTE After
restoring the appliance, the events and alarms settings are not enabled
even if the GUI shows as enabled. You can enable the Events
and Alarms settings again from the Settings tab.
Click Apply.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\